Vented Vs. Unvented Attics?! Spray foam vs. Blown-in?! What is best? (Super info dense)

Ғылым және технология

Get ready for some incredible knowledge delivery all about spray foam installation! Robert with Eagle Insulation did an amazing job on our spray foam detail for our custom ICF, high performance home.
When building a house what should you consider when thinking about insulation?
Greg interviews Robert about best practices, building science and more!

Пікірлер: 10

  • @BealyGood
    @BealyGood4 ай бұрын

    I’m going to have to watch later as we’re out here building my Icf walls but, I always go with sealed attics, because most of our mechanical stuff ends up in the attic. Interested to see what conclusion you came to

  • @walnut_trail_farm
    @walnut_trail_farm4 ай бұрын

    Dude, the VERY design decision I have been agonizing over. Thanks for sharing and well done!

  • @Mountainview-mesa

    @Mountainview-mesa

    4 ай бұрын

    Thank you for watching! Good luck with your install!

  • @MrAmcalabrese
    @MrAmcalabrese4 ай бұрын

    Good video, thank you! I am a little behind you in my ICF build, but I'm trying to figure out when to foam the roof decking. Sounds like sooner rather than later is best.

  • @Mountainview-mesa

    @Mountainview-mesa

    4 ай бұрын

    That was a big lesson for us. Luckily, our spray guy was kind and accommodating!

  • @av1204
    @av12044 ай бұрын

    I am always a few steps behind. Getting ours sprayed in 3 weeks. Going to do 4 inch of closed. Im in georgia so a lot less of a heat load then yall out in the mountains.

  • @Mountainview-mesa

    @Mountainview-mesa

    4 ай бұрын

    It makes a huge difference. So glad you're building! How are you fighting humidity out there? We live in a very dry place so I've never had to battle it.

  • @av1204

    @av1204

    4 ай бұрын

    @@Mountainview-mesa It isnt too big an issue at least not any different then any other high performance home, we just swap the erv for a venting dehumidifier and should be good to go. It will slightly pressurize the house which we want in a high radon area. As far as leaks go I am going to put a fog machine in the house for a few hours and then put a fan in the door, like a blower door with some plastic. The fog should get pushed to where ever there is a leak and be able to be seen. Poor mans blower door.

  • @samq2635
    @samq26354 ай бұрын

    Are you using your erv to vent the conditioned attic space?

  • @Mountainview-mesa

    @Mountainview-mesa

    4 ай бұрын

    Yes. There will be a full (long) video on the ERV install later, but fresh air will be making it up into the attic for sure.

Келесі