TRACKER BOAT REBUILD PART 1/ HOW TO TELL IF YOUR FOAM IS FULL OF WATER
Спорт
This is the first update on the tracker boat rebuild, the hull is pretty good but the floatation and transom were completely ruined, stay tuned and ring that bell there's tons of videos coming of this build. should be a awesome boat when finished
Пікірлер: 27
Well done my fisherman friend, your information is great, I wish you an abundant catch
Can't wait to see this rebuild completed. If it's half as good as the Starcraft 21 you'll have another great boat. Keep the videos coming.
@bowl830
3 жыл бұрын
Thank you I appreciate that.
That boat is going to be cool Jeff! Happy Fishing!
Great winter project. You do a great job. Make it better than they did.
@bowl830
3 жыл бұрын
That’s the plan. I got some ideas in my head, let’s hope I can get them in the boat lol. Thanks for watching I appreciate it
Thanks for the great info. Looking forward to the next video.
@bowl830
3 жыл бұрын
Thank you sir
Good solid information right here folks!!
Awesome work already and you're just starting.
@bowl830
3 жыл бұрын
Thanks brother I appreciate you watching
Great info brother!
Great tip
Good information thanks for sharing
@bowl830
3 жыл бұрын
Thanks for watching and commenting I appreciate it
I rebuilt the same boat 2 years ago and it had the same problems also the transom was like corn flakes had to replace it too. I got a finished video of it. And I still have it it’s a great little fishing boat.
@bowl830
3 жыл бұрын
It’s unreal how bad that treated factory transom is. I can’t wait to have this one finished. Just done the leak test on the rivets. I got 5 to replace then it’s on to the, put it together stage. Thanks for watching
Thanks for the next step...been following this series. When you removed all the old water soaked foam. What cleaned that back to all most factory look? Chemical like Alumibright or just pressure washed or....?
@bowl830
3 жыл бұрын
I used purple power. I soaked it real good. Let it set for about 30 minutes. I’d go by and must it with the hose just to keep it from drying. Then I used a pressure washer to remove it and the left over foam chunks.
Will you try to get most of the old stuff off or just glue over it?
@bowl830
3 жыл бұрын
Will remove. I’m not putting any carpet back. At least that’s the plan.
How much of the old carpet glue do you get off the aluminum?
@bowl830
3 жыл бұрын
I haven’t tried much. I sanded a little spot. It seemed to be dried out and sanded pretty easy
Do you have any tips on how to make a windshield for a tracker boat?
@bowl830
3 жыл бұрын
Like the factory side console wind shield?
@nickmayberry4209
3 жыл бұрын
@@bowl830 yes, I've got a. 1988 tracker tournament V17 and the side console windshield is gone
@bowl830
3 жыл бұрын
@@nickmayberry4209 gotcha. I’ve bent that plastic before. But you can order a console windshield on the net. It’s not factory but pretty close. It’s cheaper than you can buy the plastic most times. I’m building a complete walk through windshield for mine. I think! 😂