Thank you for taking the time to make this video. Hopefully I’ll be able to save an elderly couple some money!!

@DuctTapeMechanic

2 ай бұрын

Best of luck!

My carrion has black panel with all push buttons so my washer is doing the no drain thing and stop in the cycle

Thanks for your help! Washer back to working again.

@DuctTapeMechanic

2 ай бұрын

Awesome! Glad to help!

Is there a filter on this kind of washer? I am getting white redue all over my black pants. I have cleaned it and used the recommended cleaner. Please help

Do you think it is advantageous to do a voltage check at the drain pump connector to see if the control board and the wiring are good?

@DuctTapeMechanic

9 ай бұрын

Yes, I would recommend that, especially if you are doing technician level repair. Sometimes, in these videos, I try not to go into the deeper troubleshooting steps for simplicity purposes.

Skip to 1:45

I can trick mine to pump out. I set it to drain and spin. It drains and stops. Then I reset it to drain and spin and it spins out. What's wrong with mine?

@DuctTapeMechanic

Ай бұрын

Sounds like an issue with the RPM sensor

Hello, I have an older GE/Frigidaire stack washer dryer. On the spin cycle it sounds normal without clothes in it. When a load is put in and goes to spin it sound very loud like screeching. Any idea on what it could be? Thank you

@DuctTapeMechanic

8 ай бұрын

Sounds like bad bearing. Unfortunately, that's a tough/expensive repair

If i got 16.1 ohms reading from the drain pump is it within tolerance or is it fried? I know you said 10-15ohms Great video! Thanks!

@DuctTapeMechanic

Ай бұрын

Yes 16.1 ohms should be ok. But please be aware the pump can still be mechanically broken

🙋‍♂️..🤙👍👏...thanks...

@DuctTapeMechanic

9 ай бұрын

Your welcome!

Cabrio