very useful tips

Thank you for your helping......

@alalndt8041

3 жыл бұрын

You welcome bro

🤔🤔🤔🤔🤔🤔🤔🤔🙂🙂🙂

Super alal ❤❤❤ thankyou

@alalndt8041

3 жыл бұрын

You are welcome Bhai

Bro pls make a vedio about x- off option in weld scan and lamination how to consider..and it's use

@alalndt8041

3 жыл бұрын

Ok bro thanks you

Nice video, thanks bro!. There's another way specific to sonatest D-50, which is by using Angle measure mode in the meas menu. Default values are already 15mm for depth, and 3mm for hole size. You only need to calibrate your range accurately and make the thickness bigger than 15mm in Trig menu. Good luck and thanks for your efforts :).

@alalndt8041

3 жыл бұрын

Welcome bro v1 block hole size bro 1.5mm depth 15mm

@alalndt8041

3 жыл бұрын

Pls share with your friends bro my Ndt KZread channel thanks you very much bro

@bacelismael8687

3 жыл бұрын

It's ok, calibration blocks might differ a little bit, mine has 3mm hole, no problem you can enter whatever real dimensions of your cal block and it'll work just fine. Thank you again for your great work and videos 👍🏻.

Nice method, however why not just use the perspex disc and the engraved numbers on the calibration block. Always good to know more than one way though 👍

@alalndt8041

3 жыл бұрын

Thanks you very much bro

@alalndt8041

3 жыл бұрын

Pls share with your friends bro my Ndt KZread channel bro

Bro depth devide bp then cos-inverse But depth is ....whatever your machine showing not 15 ..... But one thing angel checking time how much thk is put your machine? I thing 15 mm thk put is currect because sdh depth is 15 mm

How to true prope angle checking v2 block please one video sir.

@alalndt8041

Жыл бұрын

This video already I make you check there have brother

@alalndt8041

Жыл бұрын

Sorry I make v1 block

@durgeshkumarsingh1518

9 ай бұрын

Alal bro Could you make 1vedio how to find true angle on v2 block. along with how to check SNR also. Plese if you have vedio send to me