Tiny House Water Solution: How to Bring Creek Water Up Hill with a Hydraulic Ram Pump - Part 1
Introducing the ultimate off-grid solution for tiny house owners - the hydraulic ram pump! This innovative device uses the power of the water hammer effect to bring fresh water up hills and into your tiny home, eliminating the need for electricity, fuel or mains water connection. The ram pump is designed to take creek water and pump it up hill to be used for small-scale water needs, making it the perfect choice for off-grid living. With its durable construction and low maintenance requirements, this pump is built to last and provide years of reliable service. In this video, we'll show you how it works and why it's the perfect solution for tiny house owners looking to live self-sufficiently. Watch now and discover the power of hydraulic ram pump water pumping for yourself!"
Buy a Ram Pump at the Land To House Store:
landtohousestore.com/
Ram Pumps available on AMAZON
amzn.to/2EWrQHN
Help Support land To House by Paypal:
paypal.me/landtohouse
Send Mail to Land To House:
Land To House llc
P.O. Box 323
Micaville, NC 28755
See whats coming up before it hits KZread on my Facebook Page:
/ landtohouse
Land To House is a participant in the Amazon Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com
Пікірлер: 18
Half inch is cool!
Close the delivery pipe valve and then pressurize the air reservoir. Slowly open the delivery pipe valve until a very small amount of water seeps into the delivery pipe. The pump should be able to keep the pressure up and fill the delivery piled. You may need to play with the delivery valve a bit.
Great system sir o7
How about an L/HDPE version instead of PVC? Not good to have pvc intakes laying out sun exposed or sitting in creeks like that. Sure you're hopefully gonna filter any intake after the run but ideally just better to use the better material. It's not that much more than pvc nowadays.
If you use a Larger upright maniflod will it increase the flow
Can you make a water pressure without electricity or fuel
The size and link of the intake pipe the more PSI is this right?
Well we know it works but how do you make one
Don't use pvc outside, just use irrigation pipe
You say you have 5 feet of head pressure how do you measure that? I purchased this exact setup from you and have been messing with it for over a month and can’t get it going. Guessing not enough head pressure?
@LandtoHouse
6 күн бұрын
If you will disconnect the pump from the drive pipe , you can lift the drive pipe up and use a tape measure to measure from where the water stops flowing out of the pipe as you lift it to the ground. Thos is the head pressure. If your drive pipe is too long it will also prevent the pump from cycling. That is why I installed a standpipe for this particular pump.
@jllaine
Күн бұрын
You may not have enough back-pressure from the delivery pipe. Try turning off the delivery pipe valve and see if you can get it to cycle on its own.
Two Words... Mosquito Spray!!! 🙂
Looks kinda fragile..like a small flood might destroy it?
@LandtoHouse
5 күн бұрын
The pump itself does not have to be in the water to operate as long as the intake is underwater. If your water sources is prone to flooding you can place the pump on the bank.
@olsim1730
5 күн бұрын
@@LandtoHouseof course. Thanks for your reply, I apologize for taking negative perspective 🙏
Havent heard that in a while.......hot water heater ...
@LandtoHouse
5 күн бұрын
Haha I know! Heat the water and heat the water.