I bought one of these lights and found it a bit rubbish with the timing 'scattering'. Glad it's not just mine

Thanks for that - I was going to buy one. I'll save the money for something else.

Thanks so very much for sharing this with us all. It’s an over priced low quality item that I will now totally avoid. Your video has saved me a lot of precious time and money. Thank you so much! 🌠🌌🌅👍🏻

I had one for many years, and it never really seemed to work very well. Not sure if it’s me or the tool !

During the build of my 1310, I picked up an SP8000 ready for doing the timing. I used it for the first time a few weeks ago and I too found the same issues as you have. For measuring RPM, sometimes it would be steady as a rock, and at other times it would jump all over the place. I found that I had to disconnect it from the car and reconnect it, this would often result in steadying the readings. I used the coil + and coolant take off nut for -ve. I also seem to recall that the plastic clip needs to be as close to the suppressor cap as possible. I am using a 65D dizzy and viper 1.5 Ohm Viper coil. I wonder if the timing light works better with different dizzys? Could you test it using a better cable setup (you mentioned the connector was the same as the Innova?).

@ACDodd

Жыл бұрын

No point in testing it, it should work. If it does not work it’s not really doing what it should

@Sternhammer89

Жыл бұрын

@@ACDodd I wondered if it was the lower quality cables that were the problem, hence maybe swapping them with the Inova?

@ACDodd

Жыл бұрын

@@Sternhammer89 I would have to work out the polarity and check the pin orientation so not going to bother with that. At the end of the day, their are better lights.

still a handy tool to own. Just maybe thats not the one to be buying.

@ACDodd

Жыл бұрын

If you only ever want to set the base timing it works

@CKblue6

Жыл бұрын

I've taken mine to the tip last month. Intermittent strobing that's if it worked at all. Bought a Snap on one and now much happier. Would never buy this item again sorry.

Don't bother, it's shit really struggles to pick up the HT feed