00:00 Intro
01:05 Cutting the Zyn container lid
02:40 Seal driver configuration
03:27 Using the tool/seal install
In this video I show how to make a cheap seal driver for the rear axle of a 1st gen Tacoma or 3rd gen 4Runner. All you need is a can of Zyns from the gas station, a box cutter, and the bearing removal tool (assuming you are changing the bearings as well).
You could also fabricate a piece of wood or something if you don’t have the bearing tool, just needs a flat surface that you can hit with a hammer.
‘96-‘02 4Runner
‘95-‘04 Tacoma
*THIS MAY NOT WORK ON ABS MODELS, AS THE SEAL SITS DEEPER WITHIN THE AXLE HOUSING* maybe buy 3 cans and stack them together ; )