I like the 3 points of contact on floor for good stability.

@6ldesignsmetalinmotion217

Жыл бұрын

Yes, that's the reason! I didn't want the whole saw to potentially rock at any rate!

That turned out awesome man! 👌😁

@6ldesignsmetalinmotion217

2 ай бұрын

Thank you very much, Corey! It has worked really well for the last nine years! Thanks again!!!

You sir are both a Gentleman and a Genius. I am very excited to build one of these. It is absolutely beyond me why this isn't a saw in production! Thank you very much!

@wolfgangsixl9283

Жыл бұрын

You are very kind! Thank you for your nice feedback! Over the years, many have said the same thing in regards that saws like this are not readily available to metal workers!

@willholt100

Жыл бұрын

Evolution just launched one of these.

@wolfgangsixl9283

Жыл бұрын

@@willholt100 Yes, I know! A buddy of mine bought one and we made a little introductory video! Feel free to check it out!

@larryenglish9292

10 ай бұрын

Evolutions is trash compared to this. And it won’t go to 15” blades. That cart is top notch. I’ve watched this video 10 times. I want to build this cart big time.

@jeremyfinkbeiner7775

8 ай бұрын

What size of Ridgid miter saw base did you use? 10" or 12". I would like to do this to my Fein cold cut saw.

Fantastic!

@6ldesignsmetalinmotion217

Жыл бұрын

Thank you very much!

Very cool!!

@6ldesignsmetalinmotion217

Жыл бұрын

Thank you very much!

Awesome job

@6ldesignsmetalinmotion217

Жыл бұрын

Thank you very much for your nice feedback! Greatly appreciated!

Thanks for the video. Is there anything you would do different if you did it all over again?

@6ldesignsmetalinmotion217

Жыл бұрын

I can't say that I would! The saw has worked great and has been very reliable for many years now! Thanks for the nice feedback!!!!

Do you remember the mofel of rigid miter saw you used for this projcect? I want to do the same with a Fein Slugger cold saw.

@6ldesignsmetalinmotion217

4 ай бұрын

The model number was MS1290LZA! I hope that helps!!!

What 2 square stocks did you use For the sliding tube in tube. I heard one is 2”x 1/8 wall

@6ldesignsmetalinmotion217

Жыл бұрын

The receiving tube is 2x2, 14ga wall, and the inside tube is 1.75x1.75, 11ga wall. I hade to grind down the weld seam in the 2x2 tube! I hope that helps!

@ThatDiegoGuy76

Жыл бұрын

@@6ldesignsmetalinmotion217 k thanks. I have a ridgid base like yours but has the slider forward and back. Do you see any issue using that base and keeping the slider mechanism? I like the way you think , setting up your shop. Make more videos 😁

@6ldesignsmetalinmotion217

Жыл бұрын

@@ThatDiegoGuy76 I eliminated the slider function for safety reasons on mine, and would not recommend it on a metal cutting saw at all!!!