Talbot Express 2.5D Thermostat Replacement. U25 Engine
Тәжірибелік нұсқаулар және стиль
Talbot Express 2.5D Thermostat Replacement U25 Engine . #talbotexpress #talbotexpressthermostat
In this video I replace the thermostat in my Talbot Express 2.5 Diesel.
Chapters:-
00:01 Introduction - is my van getting hot enough?
00:40 Location of the thermostat housing and engine bay declutter.
01:18 Lubricating the thermostat housing bolts with penetrating fluid.
02:00 Loosening the bleed screw before we start.
03:30 Freeing of the thermostat housings longest bolt very carefully the technique.
07:28 Where to place the lubrication.
08:50 Protecting the alternator before draining.
09:45 Removing the old thermostat.
10:15 Cleaning up the thermostat housing surfaces.
11:45 Refitting the thermostat QTH229K
12:40 Cleaning up the thermostat housing bolts and test fit prior to refitting.
13:50 Reassembly of the thermostat housing.
14:45 Topping up the coolant and bleeding.
16:30 Observations and thoughts as the engine warms up & Outro
Tags
talbot express thermostat replacement, talbot express, talbot express 2.5 thermostat replacement, talbot express 2.5d thermostat, talbot express 2.5d thermostat replacement , talbot express u25, how to replace thermostat talbot express
Пікірлер: 8
Nice job a bit of patience pays dividends.I would have thought 🤔 there would be gasket in with new thermostat
@TheRepairer
8 ай бұрын
So would I but that’s life!!
I had the same problem with my van, temp needle always very low. I changed the thermostat but not much difference then the fan started coming on and off intermittently. I changed the radiator fan temp sensor and the coolant temp sensor and it all works perfectly, plus the air in the cab is much warmer than it used to be.
@TheRepairer
8 ай бұрын
Thanks for sharing
I'm going to do this but leave the thermostat out as I will only be using the Talbot in warm weather and the whole system in under a lot less pressure rad pipes etc
@TheRepairer
Ай бұрын
Best of luck with job and lube them bolts well.
You should take it out and throw it away
@TheRepairer
3 ай бұрын
It was designed to have one so it stays put.