Glad to see you back, I put the resistors in the back to avoid water. My first set finally got water in them at the 2 year mark with silicone grease and lots of tape when they were in the front

Cool vid man, the lights look sick coming from another fellow Mazda 3 owner. Want to do these and DRL's as my next mod

Nice job brother!

Are these the same LED's you installed 2 years ago? Im talking about the low beam, high beam and fog lights. If so, have you had to replace them or had any issues with them? I believe they're Nova LEDs.

Looks good, what LED lights do you have? Any chance you thinking about a new exhaust?

@ConnorHilliard

4 жыл бұрын

Mr. Mazda which LEDs are you talking about? The switchbacks or my low beams? I have thought about doing exhaust but I’m debating getting a project car so if I do that my money will go there

nice nice ;)

Hello there i did bought the same kind for my Mazda and looks like the signals conectors are different what can i do there!?

@ConnorHilliard

3 жыл бұрын

Francisco Bustamante if it is different check where you bought them to see if it shows a wiring diagram or something so you can see how to wire them up. If not I’m not too sure

hi again, did you used fuse tap on positive wire or you just directly tap it to the battery?

@ConnorHilliard

3 жыл бұрын

i tapped into an existing fuse spot in the cars fuse box

@iiduke

3 жыл бұрын

@@ConnorHilliard Do you recall which fuse you tapped into?

and did you used one resistor only?

@ConnorHilliard

3 жыл бұрын

I used one for each side

is that with resistors installed or not?

@ConnorHilliard

3 жыл бұрын

Mc Lim I did wire up resistors for this to prevent hyper flashing