Tips for assembling the lid of a Suncast Horizontal Shed SKUs: BMS4700
Жүктеу.....
Пікірлер: 13
@kimzzz3laracuentes2212 жыл бұрын
Just curious how come this video plus not from start to finish? Bc the directions are not very good or clear IMO… and I’m glad I found this video. It helps it just needs from beg to end for us inexperienced DiYers.
@97clubcar2 жыл бұрын
It would be nice if you should which way the arm was
@beverlyacinapuro9058 Жыл бұрын
Thank goodness for this video. It was extremely helpful !
@igcusaw Жыл бұрын
Has anyone here pulled their sleeves up and tried to construct a shed from scratch? How long did it take you?
@ncmach1 Жыл бұрын
So why does Lowes not sell this model anymore?
@georgeeighmie52142 жыл бұрын
i just bought this unite can u show me how to put the front bar on hood have not had any luck ty
@Billster1955
2 жыл бұрын
DID YOU FIGURE IT OUT YET? Front lid bracket M needs the skinny side against the lid. Secure the two center screws first. Then work your way to each end while pressing on the end of M to flex it an 1/8 inch or so tight against the lid as you insert each screw.
@driniker6096
Жыл бұрын
Help! Step 14
@driniker6096 Жыл бұрын
Step 14???
@Billster19552 жыл бұрын
At 1:15 seconds in the video the six holes are to small for the CC screws to fit. I drilled one hole a bit larger to 3/16" but the hole is still quite tight. My next biggest bit is 15/64". Has anyone else had this problem?
@jorisvanmens
2 жыл бұрын
I’m having the same problem. Did you find a solution?
Пікірлер: 13
Just curious how come this video plus not from start to finish? Bc the directions are not very good or clear IMO… and I’m glad I found this video. It helps it just needs from beg to end for us inexperienced DiYers.
It would be nice if you should which way the arm was
Thank goodness for this video. It was extremely helpful !
Has anyone here pulled their sleeves up and tried to construct a shed from scratch? How long did it take you?
So why does Lowes not sell this model anymore?
i just bought this unite can u show me how to put the front bar on hood have not had any luck ty
@Billster1955
2 жыл бұрын
DID YOU FIGURE IT OUT YET? Front lid bracket M needs the skinny side against the lid. Secure the two center screws first. Then work your way to each end while pressing on the end of M to flex it an 1/8 inch or so tight against the lid as you insert each screw.
@driniker6096
Жыл бұрын
Help! Step 14
Step 14???
At 1:15 seconds in the video the six holes are to small for the CC screws to fit. I drilled one hole a bit larger to 3/16" but the hole is still quite tight. My next biggest bit is 15/64". Has anyone else had this problem?
@jorisvanmens
2 жыл бұрын
I’m having the same problem. Did you find a solution?
Suncast 4700
Piece of garbage don’t buy it