srt4 vacuum line how to ....

Автокөліктер мен көлік құралдары

going over the stock vacuum lines and what the solenoids do along with how to find the information need

Пікірлер: 36

  • @santiagocombest6232
    @santiagocombest6232 Жыл бұрын

    Love it great job on the video

  • @Mattsneedforspeed

    @Mattsneedforspeed

    Жыл бұрын

    Thank you!

  • @santiagocombest6232

    @santiagocombest6232

    Жыл бұрын

    @@Mattsneedforspeed do you have any parts for sale?

  • @Mattsneedforspeed

    @Mattsneedforspeed

    Жыл бұрын

    @@santiagocombest6232 yea I have some

  • @santiagocombest6232
    @santiagocombest6232 Жыл бұрын

    I just drove 900 miles to pick up a 03 srt4 for 2300 bucks and it made it home with 1st 2nd no 3rd 4th an 5th an the damm iac keeping the rpm’s up around 3 grand till you come to full stop! An I was surprised

  • @Mattsneedforspeed

    @Mattsneedforspeed

    Жыл бұрын

    sounds like your in need of a transmission, and other repairs try wiggling around the wiring to the tps and iac while idling if there's a change there is damage to the wiring it could also have a damaged vacuum hose causing the high idle while checking them or during repair its a good idea to replace the intake gasket also clean up the charge pipes and the intake manifold too

  • @Poopiestboy

    @Poopiestboy

    Жыл бұрын

    Most of the time it just the pivot arm bushings and the bushing on both the shifter cables on top of the tranny and under the center console. My buddy bought an srt 4 with the previous owner thinking the transmissions done. Was just the bushings this whole time lol. I’ve seen the clutch fork goes bad as well

  • @vicentegalvez1444

    @vicentegalvez1444

    4 ай бұрын

    Thank you for the help, I'm troubleshooting my car, learning as I go

  • @SomaPmusic

    @SomaPmusic

    15 күн бұрын

    had this issue and changed the iac. ended up replacing the tps and issue is fixed completely

  • @ianknapp3917
    @ianknapp39172 жыл бұрын

    Hey man why some days I have boost and other days I don't have boost? I don't understand....

  • @shiz7459
    @shiz74592 жыл бұрын

    ive recently tackled my boost lines and the kit i received from modern performance the wga line was shorter i ended up just going to full rubber lines afterwords due to it being simple to install maybe you have experienced this too?

  • @Mattsneedforspeed

    @Mattsneedforspeed

    2 жыл бұрын

    I’ve always been luck and had some used ones I never had a set of the new ones yet

  • @shiz7459

    @shiz7459

    2 жыл бұрын

    @@Mattsneedforspeed i see

  • @waceygehring9629
    @waceygehring9629 Жыл бұрын

    Matt I'm having problems with my newest srt4. It'll spool up 2 like 4k n than it'll just like fall on its face and. Bog out. Is that a bad turbo or maybe wastegate

  • @Mattsneedforspeed

    @Mattsneedforspeed

    Жыл бұрын

    could be a few things, check the vacuum lines hooked up correctly something plugged off that shouldn't be, does it have aftermarket waste gate? bad intake gasket, vacuum hose leak, boost leak bad bov, map or tip sensor bad not matched or tune not rescaled for the car short in damaged wiring at the main ecm plug could be one or more of these things or none, I;d look every thing over and double check can try one or 2 things go for a test ride, id guess its seeing over boost

  • @carlossosa5743

    @carlossosa5743

    Жыл бұрын

    Hey Matt’s where is ur shop at got some trouble with mine srt4 sir

  • @Pooponthecouchh
    @Pooponthecouchh4 ай бұрын

    I have a P0300 code on my srt4 and I’ve replaced coil-pack,plugs-wires,spark plugs, injectors do you think it could be vacuum related?

  • @Mattsneedforspeed

    @Mattsneedforspeed

    4 ай бұрын

    If they were replaced with known good parts id do a compression check or even a leak down and also inspect the timing belt if its off a few teeth or if the car has cams and not tuned can cause p300 or poor fuel quality too low of octane, not likely but a bad intake gasket, a vacuum leak will cause high idle a lean condition ive seen the gasket folded over on cyl #1 cause a miss rough/high idle hard start but no code or there's damage in the wiring harness some where bad plug end will need visual and can some time find by shaking the wires a little depending on the damage

  • @Adrian-ss9wi
    @Adrian-ss9wi Жыл бұрын

    I recently got a check engine light on my 04 srt4 and it showed up as “reinstall vacuum hose at intake manifold or fuel pressure regulator” what does that mean exactly

  • @Mattsneedforspeed

    @Mattsneedforspeed

    Жыл бұрын

    what was the code number ?

  • @Adrian-ss9wi

    @Adrian-ss9wi

    Жыл бұрын

    @@Mattsneedforspeed p 1188

  • @wheeliewonka4775
    @wheeliewonka4775Ай бұрын

    I have all my vac lines hooked up. My wga line is going to the solenoid but I have no boost. I take it the line off and it goes to 5psi. It’s an adjustable wga and brand new. What could be an issue? I did a boost leak test and kinda sounds like a leak in one of the lines but can’t find it

  • @Mattsneedforspeed

    @Mattsneedforspeed

    Ай бұрын

    the green solenoid is the one that controls the waste gate if it was boosting before the wg change the new one has the incorrect spring or the slack is not adjusted out of the arm correctly if its a boost leak and your using a tester can try some soapy water if there is no physical or you cant feel the air check all the connection points you can spray on the soapy water and look for bubbles you will need to jack up and support the car with jack stands as you will need access to the btm of the car also..

  • @wheeliewonka4775

    @wheeliewonka4775

    Ай бұрын

    Could I possibly pay you to go over/fix my issue? I have all the lines routed as it shows on the hood, but the boost spools slow now. Low rpms it’s almost nothing until about 4500-5k. Mods are intake, turbo xs bov, catch can, 3 bar sensors, dsp i3, bfmic, mpx down pipe and side exit. I’m in NW Ohio. I’m willing to travel or can pay you for you a FaceTime call or something lol

  • @IntegrityFirst
    @IntegrityFirst5 ай бұрын

    What do you with them if you install an air intake?

  • @Mattsneedforspeed

    @Mattsneedforspeed

    5 ай бұрын

    if your still on a stock set up you keep the vac lines hooked up some/most of the kits come with a bracket to mount the solenoid pack off the battery tray

  • @1_sick_taco252
    @1_sick_taco2522 жыл бұрын

    I'm having a problem with my srt4 .. do you think you can help? Tia

  • @Mattsneedforspeed

    @Mattsneedforspeed

    2 жыл бұрын

    ask ill try to point you in the right direction.

  • @jamoneburnett7428
    @jamoneburnett7428 Жыл бұрын

    I'm running a S3 turbo with agp wastegate. Does it matter which nipple I use off the turbo to connect the two? I hope I worded that correctly

  • @Mattsneedforspeed

    @Mattsneedforspeed

    Жыл бұрын

    Yes I think so the one feeds the solenoid for the waste gate the other is for the evap system the one for the waste gate should be the one near the end where the hot side pipe connects, the pipe under the car

  • @leeboy1.0
    @leeboy1.03 ай бұрын

    With the blue line can you just plug it up? You weren’t clear

  • @Mattsneedforspeed

    @Mattsneedforspeed

    3 ай бұрын

    if you remove all the lines to the blue solenoid u can cap the solenoid to keep the dirt out you could do the end of the lines if you feel the need.

  • @grownnotflown2
    @grownnotflown22 жыл бұрын

    What happens if you disconnect the Evap line?

  • @Mattsneedforspeed

    @Mattsneedforspeed

    Жыл бұрын

    It should technically have vacuum pulling on it ive seen lots not hooked up and no codes ??

  • @Mattsneedforspeed

    @Mattsneedforspeed

    Жыл бұрын

    @@sinfulserpentful yes that is correct also the staged ecms are labeled off road use only for legal reasons

  • @ProLogicEnt1
    @ProLogicEnt1 Жыл бұрын

    Yeah my car didn't come with this either 😒 😕

Келесі