Spudski RC How to: Hobbywing Axe Brushless Motor Calibration and ESC to Transmitter Calibration
This is a how to calibrate the Hobbywing Axe motor to ESC and ESC to transmitter. The ESC to transmitter calibration is required before use and the motor calibration sometimes if there isn’t any output from ESC to motor.
Пікірлер: 14
thank you so much, I've had mine for almost a year and it always drove bad, did what you did in this video and it drives better now
@spudskirc4458
2 жыл бұрын
That’s good to hear, glad it helped you out.
Thank you for this straight to the point explanation! I needed it, some how my axe 2 just lost calibration out the blue.
@spudskirc4458
3 жыл бұрын
No problem, glad it helped you out :).
AWESOME video!! Was a HUGE help for me!!! Thank you!!!
@spudskirc4458
2 жыл бұрын
No problem glad it helped
what could be the reason why I can't calibrate? the light on esc never turns green.
Hi thank you for this video but im having problem if you can help me i did as you but the first stage where i dont connect the esc to the receiver and i start the esc then i press the set button the motor turns one way then after few seconds stoos but it doesn't go the other direction and the green light stays green and the second stage its not doing what it should can you or anyone had the same problem can help advice me
Thx you ,
@spudskirc4458
3 жыл бұрын
No problem 👍🏼
i have problem when i turn the controller wheel the motor starts going forward or backward and i cant change it everything is just as it need to be but still doesnt work rip 200euros im using xerun axe v1.1 esc and motor is 2300kv
@drowildcat2960
2 жыл бұрын
Servo lead in rx is plugged it backwards its in the turn servo location move wire on rx to the throttle plug place in the Rx like if wire plugged in channel 1 move servo wire to channel 2 and it should work
@madrc9781
2 жыл бұрын
@@drowildcat2960 lol i needed this comment long time ago thx
By the way im upgrading my TRX 4 defender 1/10