2:29 this morning I noticed a buzz coming… That sounds like a known problem where the vacuum pump motor gets locked into the on position. It can get very hot and fail if not dealt with. Start by replacing the Volvo Brake Booster Vacuum Switch which is fairly easy to replace and see if the problem goes away.

@joeshow8815

Жыл бұрын

I appreciate the advice. When the car was at volvo for repair of the problem described in this video, they too told me, that motor was constantly on and may burn. I never looked into the issue. I didn't even know where that motor was. Until you told me now. Will follow up on it. However, I haven't heard that buzz for a while and brakes seem to work ok. Thanks for the tip just the same.

Disconnect the Battery and connect its work 100%

I had this turned out to be the haldex clutch block failed apparently due to moisture

So I had a used ABS Modulator put on my 2011 Volvo S40T5 and now my car doesn't recognize the part...? Can anyone help a girl out and give me some information on how I can get my car to recognize the replaced part? I am sure it is a coding issue, however I am not certain how to do that?

i own 2007 volvo s40, i 've seen the same message and the warning 3 months ago. because of malfunction rear ABS sensor. after installing new sensor. th same messages appear. tested all the ABS system components, all work good however the mechanics said it is probabely the ABS module. the solution was simple to me, disconnect the battery cables for 30 minutes and connect the battery again, do this 2 or 3 times.. no dashboard lights...i think this era of Volvos have a finicky electrical issues. just be sure you fix the malfunction part and do Hard Reset to educate the module.

@joeshow8815

Жыл бұрын

Thank you for that information even if I now have the ABS warning light gone, so I won't be able to try your method.

Send it back to whoever fixed it.

I am putting the below description of problems I have had with my 2005 volvo XC 90 v8 4.4l engine in case it may help someone who has similar issues with their car. main problems as of Mid summer 2022 A. ...warning lights -ABS -Brake -triangle with exclamation mark inside B. ....text warning messages : - brake failure, stop safely -passanger air bag malfunction C. ...parts /devices not working: -odometer and trip meter -AWD Steps taken to solve the problems First -ran a scan with a cheap scanner which pointed to ABS being bad. Took the ABS module out and sent it to be rebuilt. The shop tested it and verified it was bad. They rebuit it and sent it back. It did nothing to solve any of the above problems. The shop suggested it could be the instrument cluster. I had them rebuild the instr. panel and again: it did nothing to solve any of the problems I bought a an iCarsoft vol v2.0 on E Bay. . It pulled following codes U2100, (?) 8F18, (?) P2162, speed sensor A/B correlation. General malfunction AND : P1799. CAN/TCM/ABS circuit mmalfunction. bus signal/message failures. missing message. I had no clue what to do with these . I took the car to a volvo dealership. They pulled a page long list of faults Among them: the ABS was not working. And the differential pump was bad ( probable reason the AWD was not working). When I said I just had the ABS rebuilt, they said get a refund. It is not working. I got the refund. To my surprise the rebuilder was extremely cooperative and gave me no hassle. presently I am working on solving the problem of the ABS first, I took the faulty ABS out and replaced it with a used one I purchased on Ebay. Then took the car back to the dealership. Currently waiting to see if this ABS will work.

@joeshow8815

Жыл бұрын

2 weeks ago the shop informed the 2nd ABS module connects but still is not fully talking with networks. The shop said I need another ABS module. Either a new one or if I wanted to give another used one a shot. Because new cost up to $2400, I went wit another used one, which costs $330 ( $80for part on ebay +$250 for programming) waiting for a word back from the shop even as I write this.

Trzeba wymienic modul pompy abs.. prosta robota..

Hello I think u have electrical problem Check vacuum pump and abs pump But first u need check all modules through scanning device

@joeshow8815

Жыл бұрын

I have installed another ABS module and took it back to the dealership. They scanned it and said it is better than the previous but still not working fully well and advised me to get another one. I am looking for it right now. I appreciate your advice. It seems you are on the right track. Thank you.

@joe message me, I have had the same problem.

@joeshow8815

Жыл бұрын

how did you solve it?

@haggis1166

Жыл бұрын

@@joeshow8815 the exact same fault started on my 2005 XC90 D5 roughly 3 days ago. After doing some reading I went straight to the (Body Control Module) which is located in the drivers side footwell and checked for traces of water (which were present). After this you need to remove the wiper arms, remove the plastic surround and removal of the wiper motor. Just below the windscreen (drivers side) you’ll see a box, this is where the main electric cables go in from the engine bay. Remove the cover and disconnect the 2 connectors, 1 is brown and 1 is grey…… when I removed mine there was water present in the grey socket. Using a hair dryer on cold we blew out and dried as much as we could. Then inside the drivers footwell i placed a small mobile heater and also on cool setting left it running for a good hour.

@haggis1166

Жыл бұрын

I used this video as a guide. kzread.info/dash/bejne/noaYutV8lNnOhso.html

@haggis1166

Жыл бұрын

I had a couple of intermittent faults a couple of days before brake failure, trip meter, abs lights came on, and that was my windscreen wipers would randomly go on and off. Once my fault became more apparent my brake lights would constantly stay on also when the car was locked.

@haggis1166

Жыл бұрын

As for now, I’m 24 hrs further on and as of yet no faults have reoccurred. Fingers crossed it stays this way, I don’t fancy parting with €1200 for a new BCM.