Punch made to knock seized cv spline out of drive flange and doesn't damage thread or mushroom end of joint
Жүктеу.....
Пікірлер: 5
@paulcruz17143 жыл бұрын
I wish that was true all of the time.
@Timman573 жыл бұрын
So, just didn't wanna bust out the CV press or? Bolt it up to the wheel studs and crank her down with a beveled tip into that receiver on the end of the cv joint, but I guess this will also work out fine, I just try not to get into the habit of using a hammer around wheel bearings lol
@bradleywise835
7 ай бұрын
Ive always used the beveled hole for the air hammer....😅
@grahamhunt33613 жыл бұрын
Copper hammer WD40 front n rear.. job done..!
@sacha_1152
6 ай бұрын
I’ve been trying to remove my cv joint for 2 days from the hub, wd40 is not the problem solver.
Пікірлер: 5
I wish that was true all of the time.
So, just didn't wanna bust out the CV press or? Bolt it up to the wheel studs and crank her down with a beveled tip into that receiver on the end of the cv joint, but I guess this will also work out fine, I just try not to get into the habit of using a hammer around wheel bearings lol
@bradleywise835
7 ай бұрын
Ive always used the beveled hole for the air hammer....😅
Copper hammer WD40 front n rear.. job done..!
@sacha_1152
6 ай бұрын
I’ve been trying to remove my cv joint for 2 days from the hub, wd40 is not the problem solver.