I did that today took an hour thank you so much

Good work, thanks 👍

@RMFUNTIK

19 күн бұрын

@@romangoodmister thank you.

Man, thats some amazing work you did there. This looked very difficult to do but i appreciate ypu showing everything. Thumbs up! 👍🙇‍♂️🙏

@RMFUNTIK

5 ай бұрын

Please and thank you 🙂👍

The drum does not come out for me, ended up having to fix the out of wack thread as I hammered it (almost needed to buy the entire set😅). I ended up using 3 sets of zip ties to anchor from the other side, using soapy water, heated tire, and motorcycle tire levers, plus another pair of helping hands to get the stubborn tire in.. what a job. I have both front and back as permanent tires now, no more flats🎉

@RMFUNTIK

9 ай бұрын

it's all depends on a tire.. it has to be soft.

Excelente

@RMFUNTIK

6 ай бұрын

thank you!

Was that silicone or something you added before putting it back together? Is that important, because I done have any. This way of removing the back tire seems a lot easier than going through and disconnecting the wires and all that.

@RMFUNTIK

8 ай бұрын

silicone for water protections.

@svubbermand

8 ай бұрын

@@RMFUNTIK ah ok. I’ll take the other route then so I done have to disassemble the motor. I was ready to go today, and then I noticed the torx screw on the buttom is security torx.. now I need to wait for some bits to be delivered so I can unscrew them xD

@RMFUNTIK

8 ай бұрын

@@svubbermand happens 😂

How are these tires in the road compared to the tubeless tires?

@RMFUNTIK

10 ай бұрын

well it depends on your weight.. if you are 100kg+ you barely feel it.. if you like me, skinny peace of bones.. 55kg, then it will be a bit rocky :D

I do not understand the whole Zip tie thing people do. All you have to do is heat the tire up for 2 and a 1/2 minutes on each side on the micŕowave Ring which applies around the rim. Add dish, soup an 2 tire spoons and it snaps right on.

@RMFUNTIK

3 ай бұрын

no need if you have zip ties.. :)

@theebikeguy3852

3 ай бұрын

@@RMFUNTIK O k but you also remove the motor to be able to zip So how's that faster?It takes me about twenty minutes to pull a tube tire off to install a Solid tire on then reinstall for a scooter for a customer. Without taking a motor apart.

@RMFUNTIK

3 ай бұрын

@@theebikeguy3852 so what? you suggest that i do like you? i don't like this method.. i like my method. :) cheers.

@theebikeguy3852

3 ай бұрын

@RMFUNTIK Do it how you want, but I run a bike shop. Things I gotta be in and out.

@RMFUNTIK

3 ай бұрын

@@theebikeguy3852 well you can't do this job in and out so quickly... You need time do it properly, that sticky goo is a pain to clean.. and I always do my best in my work, so that the client would be happy and safe to ride.