Nice job..so very clean looking instead of what it was before.

Very good teaching I also do roofing jobs

All I can say is we do our flat roofs differently here in Wales. A 3 layer torch on system layed on Kronospan. A 40 year life. Preferably a warm roof.

@chriscross7709

Жыл бұрын

Seems reasonable for a place that gets constant rain almost year round. Here in California we don't even need to torch anything down, we can just nail it down and it'll do just fine lol.

@Loonypapa

9 ай бұрын

You're doing it the right way. This guy is not.

That channel was excellent, but your KZread channel is better. Great video. Shocking how much old roof material in that dumpster. Hard honest work. Thanks for the video. I don't know if it's just me but the video gets stuck at 9:36 when you were showing the water around the chimney. I had to skip forward 10 sec to get it to play again.

@FlatRoofDoctor

2 жыл бұрын

I don't know what the issue is. I think it has to do with KZread server. But thanks for letting me know. As always, you are the best

@MrMoss786

2 жыл бұрын

@@FlatRoofDoctor appreciate your knowledge sharing, thanks again.

Your teaching is great, I have torch down roof now that wasn't installed correctly. Going have to be redone correctly. Thanks for videos

@FlatRoofDoctor

2 жыл бұрын

Glad to help

Great job. Great presentation!!!

@FlatRoofDoctor

2 жыл бұрын

Thank you kindly!

A great Diagnosis as Always Doctor

@FlatRoofDoctor

2 жыл бұрын

Thanks

You can cause condensation in between your 2 systems

If you go over the stones, you will have a gap where hot air can't escape and it will get too hot.Accelerating deterioration of the material used for the roof-over.

Gran trabajo

I'm a professional roofer out of Tucson Union trained non-union state with over 21 years commercial residential and industrial experience trained by some real professionals and I think you are one hell of a roofer

@Tee-roni

Жыл бұрын

Wow

@Loonypapa

9 ай бұрын

Nobody in their right mind would install torch down over an existing roof. Look at all the ponding he had.

Good thing you use dark gray cap sheet this time we can hardly see all you burn marks. By the way did you tell the home owners there heating and cooling bill is going to be higher now that you removed any R value the roof had and didn't put any back?

@Loonypapa

9 ай бұрын

Zero insulation on that roof now.

You have water pooling on your channel😂

we call roofer like you cowboys

Talk into mic. Can't hear.

At 9:14 the "doctor" says, "Not much water..." then proceeds to show us a roof FULL of puddles of ponding water! But that's okay, he says at 9:16, "...a little bit of water standing like this is okay because this will dry up in a day." Really? In that environment with high humidity where his shirt is soaked with sweat? Unreal. That water might takes WEEKS to evaporate in some of the deeper areas on that roof, all the while eating into and slowly destroying it, allowing mold and moss to grow in it and all kinds of other problems.

You're not putting down a flam You're using Fibre glass granuals as a base sheet not supposed to that's not a proper 2 ply system I believe that no product suppliers would support a warranty with your applications

@Loonypapa

9 ай бұрын

You are correct sir.

What to do to prevent a large water pooling on the roof? Is that even possible to avoid?

@FlatRoofDoctor

2 жыл бұрын

I have done this for years. When a roof is completely flat, and cause some pooling in areas, I cut a channel from the pooling area to the edge. That is like pitching the roof, but in a narrow area. Logic. On this particular roof I did channels in 3 different areas, and came out very nice

@700singer

2 жыл бұрын

u put a channel for flow of water on a flat roof over a den with minimal depth?yes the roof needs either TAPERS ON TOP, OR PITCHING WHICH CAN BE DONE WITH LAYERING THE STYRO BOARDS I SUPPOSE U NEED PITCH OR CHANNELS CUT OTHERWISE U WILL HAVE PENETRATION...ON MY NEWLY CHEAPLY DONE JOB FOR 8000 there is rubber over styro board no pitch i go up after a rainstorm and push water off with a snow pusher...really ticked off...

@Loonypapa

9 ай бұрын

Rip off the old roof and install the new roof properly.

Hello.. I recently moved into a home and the history of my porch roof sounds similiar to this. I think it was a torch down, then someone put some kind of tar or asphalt coating over it probably 6-7 years ago based on Google Earth imagery. I have no obvious leaks yet, but what should I do to prolong the life?

@franktorres633

Жыл бұрын

You clean your channels periodically , just like any rain gutters or solars...

👍

Hey, Flat Roof Doctor! I am curious about a product that you use for sloped flat roofs with EPDM on top. You use the silicone seal from bergstrom. Do you have any experience with the other silicone roof coating such as GACO, Henry, Kool Seal (by Sherwin Williams), or Blackjack? Also, how many coating would you suggest on an old EPDM roof (15+ years) with a small leak when there is heavy rain (I think caused by water pooling)?

@FlatRoofDoctor

2 жыл бұрын

Hmm, I can't vouch for all the other brands. What I do know is that the fleece that comes with the Bergstrom Super Silicone Seal, is incredible. You can buy a fleece at Home Depot, made by Henry, and it is not that good. It does not work as well. My suggestion is to get the silicone and the fleece and seal the seam in that particular area on the roof. It most likely will fix the problem. No need to coat the entire roof.

What happens when channels get blocked with dirt and leaves?

@Loonypapa

9 ай бұрын

The roof surface in that area ages prematurely.

I’m curious to know about the decks on these go overs are the plywood ?concrete ? metal?

@FlatRoofDoctor

2 жыл бұрын

If you watched the video, you can tell the guy cutting plywood and I was talking about Rafters and plywood in some places So, it is a Wood structure

@caseyjohnston8843

2 жыл бұрын

Yes obviously this one is. But as far as the others like the gravel go overs and what not

Did they have any leaks from the storm

@FlatRoofDoctor

2 жыл бұрын

nope, nothing. that was close call. But always panicking when that happens

Hey flat roof doctor what make felt do you use

@FlatRoofDoctor

2 жыл бұрын

I use any self adhering base. Liberty, Mule Hide, Firestone. The one I prefer is Dynagrip by John Mansfield. That is hard to come by, but works the best

Can you come fix my flat roof? How can I hire your company?

@FlatRoofDoctor

2 жыл бұрын

text me at my tel 203 858 0080 all call

Hello doctor I want to job

Love the Trump policy comment! lol Who does hard labor in this great country?

hahahaha, He voted for Trump and now he can't find workers, votes for a clown and expects a circus

Making bullshit channels that achieve minimal positive slope is NOT more expensive than installing a taper iso product. It's absolutely wild to watch you try and talk with some level of authority while being so unaware on how to correctly roof.

Ain't no one got any job. You probably have immigrants working.

😂😂😂😂😂😂😂

When you torch cap onto cap you are attempting to torch rubber to CRUSHED UP PORCELAIN, THIS DOES NOT WORK. Spend the fucking money you were given in the quote for the proper adhesives or fucking embedded the granules on the bottom layer. This is insane that someone let you do this work on their home.