RPi Engineering A&R Amplifier And Ignition System Test - How to

Автокөліктер мен көлік құралдары

In this video we show you a simple test to verify that your A&R amplifier and coil are functioning correctly.

Пікірлер: 13

  • @markheather1488
    @markheather14883 жыл бұрын

    Really interesting. Thanks a lot

  • @edmundholmes7559
    @edmundholmes75593 жыл бұрын

    I've been running one of your earlier ignition amplifiers for about 20 years on my 3.5. The one regular failure point has been the two plugs which shove into socket on the side of the distributor. These are exposed to the weather and get dirty and corroded.

  • @RPIEngineering

    @RPIEngineering

    3 жыл бұрын

    Hi, Thanks for your comment. Yes I have had a couple of people mention this recently so its on my list of things to develop. I think a 3D printer should allow us to make something that would plug in an seal. Its not a common issue though I think it depends on the environment the car is used in. We have also modified a couple of dizzies in the past to have a two pin plug on the outside for a better connection.

  • @edmundholmes7559

    @edmundholmes7559

    3 жыл бұрын

    @@RPIEngineering It would make for a much more secure connection if you could create a proper fitting. I'm currently thinking of adapting the original on-distributor ignition amp to act as a plug.

  • @Ben-wr3wc
    @Ben-wr3wc5 жыл бұрын

    Hi, I am looking to get into contact regarding a quote on a refit, would love to send an email, where would I be able to do this, website link does not supply email. Thanks.

  • @bertiewooster3326
    @bertiewooster33262 жыл бұрын

    I think you should told us what the voltage at the coil is when cranking the engine is 9.5volts acceptable?

  • @RPIEngineering

    @RPIEngineering

    2 жыл бұрын

    We are doing a full ignition kit install where we cover far more this was just a simple quick video from years ago. However yes 9.5 volts on cranking is fine.

  • @TheMightyJoggernaut
    @TheMightyJoggernaut4 жыл бұрын

    Thank you, guys!

  • @gavin1232009
    @gavin12320093 жыл бұрын

    Anyone know where the vac pipe on top of the plenum is supposed to go ? Does it go somewhere onto the distributer ?

  • @RPIEngineering

    @RPIEngineering

    3 жыл бұрын

    Yes it does.

  • @dani-ohciao
    @dani-ohciao3 жыл бұрын

    Hi, im daniele. I have restored a 3.5 engine, but at the First start, i listen an esplosion on the air collector. I supposed an incorrectly spinterogeno position. For you what is?

  • @RPIEngineering

    @RPIEngineering

    3 жыл бұрын

    Hi, Yes it most likely is incorrect ignition timing. Turn the engine to TDC on the firing stroke and then make sure that the rotor arm is pointing to number 1 plug lead.

  • @dani-ohciao

    @dani-ohciao

    3 жыл бұрын

    @@RPIEngineering OK thanks a lot. Afternoon I try.

Келесі