very good presentation

Great job! Looks awesome!

@antonmursid3505

Жыл бұрын

Antonmursid🙏🙏🙏🙏🙏💝✌🙌👌🇮🇩🇮🇩🇮🇩🇮🇩🇮🇩💝✌🙌👌👋

Probing with the weld wire is pretty clever.

@tylervxxx9256

Жыл бұрын

Looks like touch sense. It's pretty handy

@benargee

Жыл бұрын

Yes especially how it trims and probes a known datum to account for error in the wire.

Love fanuc robots.

Good Job

Good tech👍

good on every welding start make TPS again . good engineer

Look great but question on what higher value product it can made

Is the back gauge on the press brake needed in this set up, what’s the accuracy of the robot vs the back gauge?

@AutomationWizardry

Жыл бұрын

It is needed. The robot is pretty accurate, but you can’t accurately bend a piece of metal that bends and warps. The robot can’t compensate that, so you need back gauges to get rid of the inherit uncertainties of the part. Hope that helps

How did the programmer keep singularity from causing a big issue? I see that forearm whipping around.

@ndleonard

3 ай бұрын

It is possible to use joint movements to avoid singularity. I often have to do so to get tooling onto a position I need it to be in.

wtf is that config on bending robot, why second axis is going below like that, could you ceep the same range on third axis throu out whole proces? was there problems on 5th axis if robot would have more common configs?

Arc welding is not in good position. You should be using a positiner while welding.

@williamlogan1775

4 ай бұрын

CJP is CJP no matter what angle your torch is at. Only issue you might have pulling away like that an that angle is shielding gas but if thats all its welding it wont be an issue.

Hanzhen harmonic drive gear , automation joint gear , robot gear , over 30 years experience

Antonmursid🙏🙏🙏🙏💝✌🙌👌👋🇮🇩🇮🇩🇮🇩🇮🇩🇮🇩💝✌🙌👌👋

More job loss