I tried the Tippmann and didn't like the results. I now run a DMK22C LVOA from Kriss Arms and have been impressed with the accuracy and reliability. I don't clean the barrel on the bolt and chamber, just under 3k rounds thus far. The DMK is quite a bit heavier than the Tippman at over 7lbs without optics, to me it feels more solid. SA rimfire is a challenge and fun times no matter what.

@ConventionRejected

3 ай бұрын

I wondered how the Kriss rifles performed. I'll have to try one eventually.

Great job Austin Hope you enjoyed the COF love seeing this

@ConventionRejected

3 ай бұрын

Definitely had fun, looking forward to the next one

Man I love your content. Would love to see a video overview of the gear you run

@ConventionRejected

3 ай бұрын

Outside of what I point to in the beginning of each video I try to keep it pretty simple, for these matches the only relevant gear are the cheap caldwell bags.

Figure out what the issue was? I have similar set up.

@ConventionRejected

3 ай бұрын

I believe it is buildup in the chamber. What the buildup is, I do not know yet.

@patrickl4186

3 ай бұрын

@@ConventionRejected That was my initial thought. Probably carbon and lead buildup. I borescoped mine which had a ring of fouling right before the rifling. Used boretech rimfire blend & C4 carbon remover and soaked that area for 5-10 minutes and cleaned with nylon bore brush. Took a couple of times but chamber is like new. Also had issues with norma 22 which would got stuck at times and wouldn't extract.

@ConventionRejected

3 ай бұрын

@@patrickl4186 when I looked briefly at the match it looked like the buildup was about halfway into the chamber, not where a carbon ring normally forms.

@patrickl4186

3 ай бұрын

@@ConventionRejected Hopefully its something simple to address. Good content. Keep’em coming.

Try not to run 2000 rounds between cleanings.