Worn rear bushes are a Ford tradition since the MK3 Cortina

When I change my cars oil at every 5000 miles . Thankfully by use of a mechanics lift . I liberally spray 303 Protectant on all rubber parts . As this will help them resist drying out and cracking .

Removing the old bush is really easy. Obviously it doesn’t matter how destroyed they get as the are heading for the bin anyway. So get yourself a good electrician holesaw and arbour. It needs to be larger than the aluminium internal bolt holder but smaller than the hard plastic shell of the bush. Simply run the cutter through, then carefully with a recip saw if you have one or a reversed hack saw. Blade through the big hole then reattach to the saw. Carefully cut the hard plastic without damaging the metal. One good hit with a mechanic chisel or an old screwdriver and she’s out. To clean the inside, a cheap old flappy sand paper disk in a drill does a great job.

I’ve struggled to get those bushes out before working in a busy garage done a lot of these all I do is gently hear the eye of the axle that contains the bush and a couple of swift blows with a hammer and they fly out works every time 👍

Mine were an advisory on the last MOT. The garage changed them as it was a bit beyond my limited DIY mechanic skills

Great instructional video, personally i think the air hammer is abit of a rough way of doing this job but you did a great cleanup i go for the drilling and sabre blade reciprocating saw method myself

Very detailed video. Thank you.

Great stuff

Excelente video. Gracias a la traducción pude entender. Saludos

I find the easiest method to remove is to drill 1 or 2 holes with 6 mm drill bit between edge of bush splitting the plastic surround then couple hits with hammer and comes out. Great vid though.

Good video make more 😀

These are easy to do . Just use a hole cutter on a drill to take the central part of the bush out. Then get a air saw and cut the metal bush carrier . Once it’s cut through it will break the tension and can be tapped out easy. Then use a bearing puller to pull the new bush in.

I can't understand why a simple round bush has to be positioned in a certain spot like this?

@mopedbanzi3275

15 күн бұрын

i've wondered that too if it's today with the cutouts in the rubber and how it flexs possibly ?

Just replace with poly bushes.easy peazy

@Kenny.1979

3 ай бұрын

How do you reposition the bracket to the exact position it was in before removing?

@tony78uk48

2 ай бұрын

I did that on my golf when they went .🙂👍

Shouldn't have used air chisel as youve damage the axle cut with hacksaw. Wouldn't use your garage lols