Replacing Bow Straps on a Z3 Convertible Soft Top
Due to a partially-botched soft top replacement (which was entirely my fault), the rear bow on the BMW Z3's soft top could not be correctly aligned. In this video, I go back and replace the makeshift rear bow straps with a factory-like solution to fix the problem.
00:00 Bow Alignment Issue
03:28 Replacement Bow Straps
04:23 Bow Strap Replacement Procedure
07:26 Unbolting Tack Strip
11:11 Removing Butyl Tape and Raising the Tack Strip
16:22 Replacing the Bow Straps
17:54 Re-Installing Soft Top Rear
20:05 Re-Installing Soft Top Head Liner
21:26 The Result
Some Tools and Materials Used
• Convertible Top Guys 1996-02 BMW Z3 Tension Strap Kit, 4 pieces TS 646
• 3M Windo-Weld Round Ribbon Sealer, 08611, 5/16 in x 15 ft Kit
• Milwaukee 2447-20 M12 3/8" Crown Stapler
• Milwaukee M12 Cordless 3/8" Ratchet
• Craftsman Nextec 12V 1/4" Impact Driver
• Arrow Fastener 50624SPTP 3/8" T50 Staples
• BMW 54318410918 Soft Top Installation Kit
• 10 mm socket
• T40 Torx Bit
• A variety of trim removal tools, picks, awls, screwdrivers
• Blue painter's tape
• Moving blankets, towels
Related Sites
www.convertibletopguys.com/co...
Пікірлер: 6
Very good video, I'm about to replace my top. Thank you.
Right in the middle of this project right now this is super helpful
About to tackle this, thank you for this informative video! I am sure you just saved me from several costly mishaps, LOL. Great job!
I hope will never have to go through this. But thank you. Amazing job
I have noticed inside the car you got at the bottom of the rear frame a seal. Have you placed it there or is it genuine one? I am asking because I do not have it and occasionally little leaks go through there. Thanks for the informative videos 👍
Sorry if I missed it but which plastic piece is the one that always breaks?