Replace rubber door seal in Beko washing machine
Тәжірибелік нұсқаулар және стиль
Before you start replacing rubber door seal in washing machine, REMEMBER TO DISCONNECT THE POWER AND WATER!
The rubber door seal on a front-loaded washing machine will eventually develop mould, tear, or crumble apart. Purchase a new seal made exactly for the model you have, and you can replace it yourself. This is a fairly straightforward job in models with removable front panel, like Beko.
NOTE: I replaced the Rubber Door Seal in the BEKO WMB71642W washing machine. For this repair, you need screwdrivers with PZ2 or PH2, PZ1 or PH1 and Torx20 bits. The PZ1 / PH1 screwdriver is needed to remove the door switch. You cannot unscrew it, but disconnect the plug from it. Reconnecting the plug can be a bit of a hassle. That's why I prefer to unscrew the switch, it's easy.
*******************************************
- If you enjoy my content and like to support me then I’d be so grateful for a virtual „coffee“. Any amount is welcome and goes a long way to keep me going. Thank you. www.buymeacoffee.com/knemo
- I'd love to hear your thoughts. Please comment, like and let me know what you'd like to see next.
Subscribe for the latest videos: kzread.info?sub_confir...
#knemo #repairs #washingMachine #beko #brokenWashingMachine #WashingMachineRepair
Пікірлер: 81
Excellent demonstration. Really helped when you showed the tricky bits were genuinely tricky. Thank you.
Really helpful. No annoying talking either.
@k-nemo
9 ай бұрын
Thanks a lot :)
Just watched this before I attempt mine. I'm really glad I have seen that its not as simple as just pulling the old out and putting the new in. This video is excellent.
absolutely superb, thanks, my machine had something wedged between the inner and outer drum, stripped it down and got the debris out, thanks 👍👍👍👍👍👍👍
Thanks for all. I have a Beko and it's exactly same step. Screws are different but will be ok. Thanks for all of dude
Cheers that was very clear and I managed it myself thanks
@k-nemo
2 жыл бұрын
No problem 👍
brilliant video
All worked fine...the pain for me was the last spring to stretch out...I had to burn the spring to spring for easy insertion (cheated) but all tested working fine ... thanks so much for the video....❤
@k-nemo
3 ай бұрын
Glad I could help!
@MoShez-dm8wm
6 сағат бұрын
Did you just apply heat? I been at it for over an hour. Horrible spring
Sorted my machine out many thanks!
@k-nemo
10 ай бұрын
You're welcome!
One of the best lesson 👍👍
@k-nemo
2 ай бұрын
Thank you!
Gracias por tu ayuda👍👍👍
Thanks😊
Such a good video. Thank you so much!
@k-nemo
4 ай бұрын
You are so welcome!
Thanks
Thnx soooo much 🤗🤗
I got the beko washer dryer and having some difficulty getting the control panel off! It feel like it’s going to snap or break it will not click out of the middle even though all the screws are out. So having to replace the seal with the control panel on it literally will snap if I try and force it so not bothering as want to sell it. But needs a new door seal having loads of difficulty because the dryer lip keeps slipping off every time I move the drum back. So given up for this evening. 😩
ما شاء الله تبارك الرحمن الله يبارك في عمرك ويرزقك من حيث لا تحتسب
@k-nemo
6 ай бұрын
شكرًا
@k-nemo
6 ай бұрын
De nada
9 years old - quite a good age for a budget washing machine
@k-nemo
2 жыл бұрын
It was a good purchase :)
@user-kc5nc8qf4c
Жыл бұрын
@@k-nemo قص
@guineagirl5078
8 ай бұрын
My beko dryer lasted 3 years. My beko fridge lasted 4
Brilliant thanks
Just like everyone else... Thanks alot..
@k-nemo
Жыл бұрын
I hope the video was useful.
Top, thank you 👍
@k-nemo
4 ай бұрын
Thank you too!
thank you!
@k-nemo
Жыл бұрын
You're welcome!
Thanks!
@k-nemo
Жыл бұрын
Welcome!
When clipping the seal back on should the lips of the seal go underneath and on top I can't seem to make them connect together. Common sense says yes but it's really hard so I'm wondering if I have the wfong size seal? Thanksn
@k-nemo
8 ай бұрын
It's hard for me to advise you if I can't see it. Compare with the old seal.
Thank you
@k-nemo
Ай бұрын
Thanks.
thanks
@k-nemo
Жыл бұрын
Welcome
Not replacing the rubber but my outer spring just came off and cant seem to get it back on if i pull to hard the rubber comes off so i have to re seal it and try again but it doesnt work any tips?
@k-nemo
Ай бұрын
Maybe ask for help? It might be easier with 4 hands.
if you have locate the hole cant be repaired just with a simple repair kit for tyres?
@k-nemo
3 ай бұрын
I don't think it will work. The tire works differently. The tire has high pressure inside.
Is it possible to change the rubber without dissassembly the front of the washer?
@k-nemo
4 ай бұрын
Theoretically it would be possible. But without access to the water tank from the front, very difficult. In my opinion, such attempts are a waste of time.
@mihailopajic7106
3 ай бұрын
@@k-nemoim authorized tehnician for Beko and it is possible to change it without removing anything else just a rubber.
@mihailopajic7106
3 ай бұрын
Yes
I tried to do this today and failed, I think the machine is a newer version so the seal is not easily accessible. I've called out the repairman. Some you win, some you lose.
I’ve got a showering leak underneath like a little waterfall. Does this mean I need to change seal?? It’s seeping
@MoShez-dm8wm
6 сағат бұрын
Possibility
Is it best to heat up the spring before putting it on?
@k-nemo
Сағат бұрын
No.
Danke!
@k-nemo
6 ай бұрын
Thanks!
@marcog.4814
6 ай бұрын
Somehow my five year pushed the whole sealing into the washer and turned it on… you saved me a lot of money cause of your video. Worked perfectly!
Trying to put the spring wire back on the outside of the seal, all it does is pull the seal off
@k-nemo
6 ай бұрын
Maybe the seal wasn't in the right place?
👍👍
💪
Where to buy the door seal?any website?
@k-nemo
Жыл бұрын
There are many stores around the world. Use the search engine.
You can replace it without taking off front panel and other stuff
Ah perfect mate! This video was a great help. Can't fault you! Have a coffee on me as a thanks £ 😉
🙏🏻👍❤️
Washing machine having a wee
Dacă se alimentează cu apă dar nu avrte ce este de facut
Во это мастер 🤦🏻♂️😡все грязные детали поставил назад 😂
Stupid idea. It’s take 2 minutes to change seal .
great video! well here goes! wish me luck haha
@k-nemo
4 ай бұрын
I wish you luck and patience when installing the springs 06:57 and 09:02. It's not easy but I did it even though I'm not very strong. 👍
@EmilieWelch-cm7qz
4 ай бұрын
I managed it!@@k-nemo Thank you so much for this video. It's been so helpful. Amazing. You weren't wrong about the springs not being easy to get back on! haha plenty of swearing while I was struggling with them but we got there using a screw-driver to ease it in place. Thanks again. Legendary video.
@k-nemo
4 ай бұрын
Well done!@@EmilieWelch-cm7qz
Thanks
@k-nemo
9 ай бұрын
Thank you for watching and supporting!😊