Nice video bro. Keep it up! I sent my car to solve this problem at Proton service center and cost me around RM54 for the seal rubber and RM60 upah pasang and cleaning. I'm not brave enough to do this on my own haha

@CTBLiew

2 жыл бұрын

Help subscribe to my channel for making it bigger so that I can afford to make more meaningful videos. Thanks.

Thanks for sharing ... i am going to fix the cover soon ... also need to do a "body check" on my 5 years old proton persona ... there is some unusual sound especially on 1st gear acceleration ... not sure whether you know this issue or not

@CTBLiew

Жыл бұрын

Do you mind share the result? Is the bear box alright?

hi liew, wanna ask - if you apply the silicone glue all around beneath the rubber gasket, would it be harder to take off the gasket next time around?

@ntonytay

4 жыл бұрын

Yes it willbe harder to take off definitely.

@CTBLiew

Жыл бұрын

I think rubber grease will be better.

Hi I have proton gen 2 campro 1.6, would like to know if you could tell me where the pcv valve is located on my proton gen 2

@CTBLiew

2 жыл бұрын

Better send it to foreman.

sorry to post on an old video. but, do you know the tightening sequence and torque for the rocker cover?

@CTBLiew

4 жыл бұрын

Generally starts from the middle near the spark plug and then move your way out. Try google image for tightening sequence for rocket cover. Match image that fit your car engine and follow the sequence.

@caerxm

4 жыл бұрын

@@CTBLiew will do. thank you

hi, i am driving a satria neo non-cps 2008. when i open the oil cap, i can see oil, is it normal? is that compartment suppose to be flooded with oil?

@CTBLiew

5 жыл бұрын

Do you open it after the engine idle? Normally the oil could have sink after stop for overnight.

@lancepoh1269

5 жыл бұрын

@@CTBLiew i open it the next morning. meaning the car is idle for at least 12 hours. is not normal right? actually 1 months ago i change my engine oil to 15w50 because my car engine has this "tak tak tak" sound which the mechanic told me likely is the valve issue. so he recommended this thicker oil. in fact after using it i stop hearing this sound

i want to try this and the only thing i want to say is, nice glove bro

@CTBLiew

Жыл бұрын

Person safety is important. Visit my channel again.

Thank's bro.. your video really help me a lot's. Hopefully you can upload a video's how to replace timing belt with D.I.Y.

@CTBLiew

8 жыл бұрын

Hi there ! You are welcome. Will make one during my next repair for timing belt.

Hi, Thanks for the video.. May I ask how much it will cost me if i send my car to the workshop to do this?

@CTBLiew

5 жыл бұрын

Around Rm80 or less depends which area.

Hi bro may i know, its different between persona campro & iafm? Because i'm worry buy wrong gasket? Thank you

@CTBLiew

4 жыл бұрын

It should be the same. One safe way is to open remove the grey cover and check see if the cover looks like in the video.

Need to flush engine oil 1st or no?

@CTBLiew

4 жыл бұрын

No need if the engine is cool.

Hello Liew, thanks for the video. I have a persona 2014 and I need to know how to replace the gear shift silver frame (like leather knob in manual shift) without removing the console. I know it's not a mechanical question but if you know I will be very thankfull

@CTBLiew

8 жыл бұрын

+George Marcos Hi there ! I have one video in the same play list about changing the blacklight. kzread.info/dash/bejne/nHVhp8xvZ6W0pps.html You may find it useful. But i think the sliver frame could be pop out easily. Careful not to break the plastic notch that holds the frame into place.

@kentkenny3248

7 жыл бұрын

hello liew...can you make video...how to install ģroungding cable

was this leak really came from the gasket? this one looks like the oil leak came from the cap.

@CTBLiew

Жыл бұрын

True. I have also made another video to show the seal for oil cap.

Is there any need to disassemble the spark plugs inside the housing

@CTBLiew

Жыл бұрын

No need.

really great video bro..

@CTBLiew

Жыл бұрын

There are more video in my channel. Subscribe for more.

Is this a real campro engine? As i know campro engine got 2 profile inlet cam(low & high) like vtec..

@CTBLiew

Жыл бұрын

Located behind the engine.

Thx fr the sharing,mine(persona 09)IAFM start to have some leakage at the area of spark plug no4 frm left..may I know where can I buy the rocker cover gasket and the price around how much?I would like to try DIY it fr first time..hope nothing's bad gonna happend..thx..

@CTBLiew

8 жыл бұрын

I got original part. Can't remember exact how much but I did mentioned in the video. Around few ten ringgit. Also got to apply little amount of RTF sealant over the outer curve. Be caution not to apply too much until the sealant got its way into the engine.

Very good sharing...nice video...

@CTBLiew

9 ай бұрын

Welcome to visit to my channel again.

thanks for the video: I will be very thankful if you can provide a video about how to change the timing belt for this Persona

@CTBLiew

Жыл бұрын

Hi George, have you found the guide for getting trimming belt changed?

very good sharing and good effort bro

@CTBLiew

8 жыл бұрын

Thanks !

very well done! Keep it up!:)

@CTBLiew

Жыл бұрын

Have you managed to do any maintenance to the engine?

very useful video!

@CTBLiew

7 жыл бұрын

=)

hi,did i need to drain all my coolant and lubricant oil before open the cover?

@CTBLiew

7 жыл бұрын

It is not required to do so. As long as your engine is cold.

@tankeanhoe8189

7 жыл бұрын

my car is 2006 myvi 1.3 is same too?

Bro, actually you can just press on the pin on the plug coil then pull the cable then it will come out without remove the pins

@CTBLiew

4 жыл бұрын

Do you mean the black rectangle spark plug head can be remove? I have been thinking of a way to remove it. Good info. I plan to give it a try.

@jiechoy9223

4 жыл бұрын

@@CTBLiew I mean the pin where the cable connected with the black rectangle head, the rubber tube under the black rectangle head also can be replace when the rubber is harden or crack

Seng Choy Liew like your work X3

@CTBLiew

6 жыл бұрын

Thank you! Have you seen my other videos?

Hi bro.. Where is your shop located?

@CTBLiew

5 жыл бұрын

I do not have physical shop. Virtual shop for your referencing.

very useful. tq for sharing.

@CTBLiew

6 жыл бұрын

This video was made to remind myself of what to do when i need to change the gasket again after three years later.

hi bro, do you know why the radiator fan keep running on and off after the engine is switch off. eventually it happen after sometime and could last for more than 1-2 hours, also happen when engine is warm. .. I am afraid it might drain my battery

@TheCc8195083

7 жыл бұрын

Alvin Joseph the problem is you one fan motor is failed already.

@TheCc8195083

7 жыл бұрын

Alvin Joseph because I facing the same problem and check the aircond fan motor didn't running.

@alvinjoseph6725

7 жыл бұрын

Hi chun, I had ecu problem n had to replace... now everything working well

@CTBLiew

8 ай бұрын

Try refer this: Tell sign to prevent overheated car engine| Drivers must know what to change| kzread.info/dash/bejne/Za2AxKapgLTdo6g.html

I already replace the gasket twice and the oil leakage still happen. Why? Thanks for the advice and video sharing.

@MrDanialkl87

6 жыл бұрын

Yunus Malik pakai silicon valve cover gasket

@88yie

6 жыл бұрын

Ni yg aku risau. Aku baru je nk tukar ni. Terfikir jugak nk kena tembak angin hos2 yg connect ke rocker cover tu. takut subat. Tu yg jd balik leaking.

@warnacokelat

3 жыл бұрын

oil cap.

@CTBLiew

Жыл бұрын

Normally oil cap if all the nut has been tighten.

@YunusMalik

Жыл бұрын

@@CTBLiew Thanks Bro for the respon... My Persona still in good condition even over 10 years old already 😅

Whats the nut size for waja cps engine cover mate?

@CTBLiew

4 жыл бұрын

Size 10.

@nic6147

4 жыл бұрын

Looking forward for your new vid, thanks mate

good job this engine for proton persona 2009 1.6 ? how to buy spear part from website ?

@CTBLiew

10 ай бұрын

Shopee should have many. Perhaps can try look for spare part shop from Google map.

Today I've removed all the screws, but I can't open the cover

@CTBLiew

5 жыл бұрын

It is the same model? Which cover it is?

@osmanbaykan5019

5 жыл бұрын

2009 Gen 2 persona, After removing the screws, does the cover open easily

@osmanbaykan5019

5 жыл бұрын

What I did didn't move the cover

what's the tightening sequence of the bolts ?

@CTBLiew

5 жыл бұрын

Look online for the picture sequence. A star sequence.

Nice video

@CTBLiew

Жыл бұрын

Thank you. Subscribe to my channel for more videos.

what happens if silicone fall in the engine?

@CTBLiew

6 жыл бұрын

That’s why some places does not allow the use of those silicone gel. I tried not to over do it.

hi..how do u clean the head cover?

@CTBLiew

8 жыл бұрын

+Abdul Hafiz It was a long and daunting procedure. I washed it with quite lots of soap. Then use hot air to dry it off. Almost a few hours performing the cleaning. I suspect there are product out there to do the cleaning in a more efficient way.

nice bro thanks

@CTBLiew

8 жыл бұрын

+azhar mansor You are welcome.

Can help me change the gasket please

@CTBLiew

5 жыл бұрын

Thank you. I take that as compliment.

hey bro i using saga flx... can u upload more about this campro iafm engine.....i love to refer your vdio..thums up

@CTBLiew

8 жыл бұрын

Thanks for your continuous support ! Will make more as time goes. Required quite some planning ahead of making video.

@cecapit

8 жыл бұрын

+Liew Seng Choy owesome thanks

Hi may I know where can buy the plug coil boot rubber?

@CTBLiew

7 жыл бұрын

You may get it from Proton Service Centre. It is cheaper.

@TheCc8195083

7 жыл бұрын

Liew Seng Choy OK thanks for reply~😁

@TheCc8195083

7 жыл бұрын

Liew Seng Choy one pcs is how much ya?

@CTBLiew

7 жыл бұрын

Will be around Rm100 per piece.

@XYuan.1015

7 жыл бұрын

+Liew Seng Choy your engine when run more than 3k rpm got noise？？my can hear that bit noise when 3k rpm where you from??

bagus..

@CTBLiew

2 жыл бұрын

Help subscribe to my channel for making it bigger so that I can afford to make more meaningful videos. Thanks.

Gasket persona and saga flx is same?

@arkintahir6342

5 жыл бұрын

Ive used the same. Saga flx gasket.. my car persona 2010.

@CTBLiew

Жыл бұрын

Indeed. Subscribe to my channel for more videos.

Do you have any idea about this

@CTBLiew

5 жыл бұрын

Does the cover refer to the grey cover ?

@osmanbaykan5019

5 жыл бұрын

I can't open the rocker cover not the the top cover. I screwed off all the screws but it didn't move

@osmanbaykan5019

5 жыл бұрын

I can't open the rocker cover not the the top cover. I screwed off all the screws but it didn't move

Normally no need glue for it

@CTBLiew

Жыл бұрын

Unless it starts to leaks.

Who ask u to seal the gasket only seal the curve area

@CTBLiew

Жыл бұрын

Yes indeed after few cycle found that apply sealant throughout is the best to prevent leakage. However it increased the risk of sealant came off and cause engine coolant holes blockage.