Thanks, very good instruction and what a immaculate restoration!

@SBRenos

2 жыл бұрын

Thanks Joseph.. I’m sure there are other ways of doing this. This is just how I go about it 👍

Hello i have an old suffolk swift push mower. I am still confused, does back lapping also sharpen the bedknife or does this only sharpen the cylinder.

@SBRenos

20 күн бұрын

It will do a bit on both.. Think of backlapping as liquid sandpaper being squished between the cylinder and bedknife which results in sharpening.

Engage the clutch so it has the resistance from the motor??

@SBRenos

2 жыл бұрын

Thanks Lachlan, I did actually do this but edited it out. It still spun.. When I assembled the mower I used an impact driver to tighten the nut, I think that’s way it was so tight..

Did you have your reel sandblasted then powder coated then sharpened?

@SBRenos

2 жыл бұрын

Yes.. I had it sandblasted, etch primed and then painted, but if you were to have it powder coated it would be the same, sandblasted and then powder coated 👍

@robertsaez3587

2 жыл бұрын

@@SBRenos thanks for that mate! Just quickly I have a SB40 electric and trying to source new bedknife would you know anyone I could source one?

@SBRenos

2 жыл бұрын

Corbin from Brisbane Cylinder Mower Specialists should be able to make you one.. Or at least point you in the right direction.. Look him up 👌

@robertsaez3587

2 жыл бұрын

@@SBRenos thanks heaps mate got in touch them and they will make one for me cheers!