Dudeeeee. This is one of the easiest things I’ve ever done getting my garage door opener remote programmed! It was less than a minute to do. This is so simple for reference

Work like a charm. Programed 2 in less then 2 minutes. Thanks!

You are the best! Thank you so much for sharing this video. Very simple and straight to the point. Merry Christmas

This worked the first time I did it, and then, all my other remotes stopped working. And then I reprogram to all the other remotes and now the new one doesn’t work at all.

Thank You it was very helpful. Have you ever had the garage door opener beep and wall control shows red and yellow light blinking. I tried to locate the backup battery but I do not believe it has one. Thanks!!!

Good video! In my case, the first step was getting a new battery for my remote hahaha

This opener is a 139.53985 and the remote is a 139.53753 for those wondering.

Well that was amazingly helpful in less than two minutes I don’t know why it doesn’t have a couple thousand upvotes !

Thanks! Now I can open from my car too!

Thank you very much. Likes, subscribed.

thx so helpfull saved me so much time

Hi, how do you program the other 2 buttons? For the light, and to lock the door.

how do you program two remotes?

very helpfull

How do you enter the code on the outside push button panel (Craftsman 315 1/2 hp)

What happens if the bulb doesn’t go on

You clicked it 3xs right?

so much easier to follow this instructional video than the instructions I found elsewhere. Thanks!

I had a Craftsman 1/2 HP too, but it did not work. The receiver did not capture the signal from the remote opener (the light did not blink). I even tried with 3 differents remotes (2 Craftsman and 1 LiftMaster). About a year ago, it worked just fine. I can open and close the garage using the remote. Then about 6 months ago, I cannot close the garage door with the remote (OK when open it). Now, neither close nor open, ain't working. The garage lift motor is about 8 years old. Any idea? Thanks for sharing!

@McCAlexander

7 жыл бұрын

you need new batteries

Thanks lol

Original remotes lost. Adjacent opener in garage remote attempted to be used (3 button remote) main button opens one door and I'm trying to set the second button to open the door I lost the other remotes for. I'm able to reprogram my remote/second button to open n close the door but it disconnects from the keyless entry pad. I reprogram the entry pad and it disconnects from the remote. Both will not connect at the same time.. Any ideas? 1/2 hp craftsman 2001, 139 model

@winkmartindale8813

Жыл бұрын

try first clearing all codes at the garage lift motor. you can find the process for that on KZread. usually hold the same button that you use for the remote learning till it clears and light goes out. Then follow the learning process for the remotes and the key pad. Clearing all codes first is important.

bought a house with a garage door craftsman 1/2 hp some reason it opens up by its self in the middle of the night? why is that? anyone else had this problem?

@jorheybhai

Жыл бұрын

Your neighbors remotes work on your opner it happens with me

This isn’t how to program a remote, it’s how to program the opener

@kremeoner1332

2 жыл бұрын

how do you program the remote to the opener?

My opener has no learn button, just a red reset button. 1396555000.

@melman18

3 жыл бұрын

We're you able to program a remote to your opener? I have that same model and I'm currently looking for which remote to buy and videos on how to program them.

@2002MX5

3 жыл бұрын

@@melman18 No. I threw it out.

It ain't rocket surgery people.