I have a pre or 932 and the ift box is just clicking

Greats job Thank You !

Do you have a specific company for lower board repair?

@coloradocardio

5 ай бұрын

Circuit board repair out of Madison, WI best we have found

Code 30 is erased after a minute, I program it and it only assumes that it is running but the engine does not start. .

Hi, my Precor displays "Please use another treadmill" then powers off. I have to turn it off at the wall and wait about half an hour before turning it back on, but then the same message appears. Ideas? Thanks.

@coloradocardio

Жыл бұрын

Need to replace the IFT box you can send it in for repair for approx $200 or ebay has them for $300

Hi I have a precor EFX 5.21 I. Elliptical giving error 30 code any suggestions?

@coloradocardio

2 жыл бұрын

This is a communication error problem, the bottom motherboard is not talking with the upper motherboard. Check your connections and mare sure they are secure. Then in the back of the upper screen make sure the phone cable is plugged into the correct spot there is two it can go into try switching those.

Hey i got an error 30, i am going to try to switch the cat cable, but it is possible that the pins in the connector are bend down too much, somehow it is still allow the pca to display (i need to confirm but iirc if no rj45 are connected the pca is not displaying anything). Thanks for the video BTW

@avenger850

6 ай бұрын

Did switching cat cable worked for u ?

@GG64du02

6 ай бұрын

@@avenger850 Not yet tested. Working on something else for now.

Do you know anywhere to get the cable the only place I can find and it’s for like 260

@coloradocardio

5 ай бұрын

Gympart.com

How long how long is that cat cable

@coloradocardio

2 жыл бұрын

Approx 6 feet

Hola me encuentro en Colombia y mi precor me sale error 30 me puedes ayudar pero no hablo inglés

@coloradocardio

Жыл бұрын

Si

@hernanhernandez404

11 ай бұрын

Pero me podrías ayudar

@juliozapata5046

3 ай бұрын

Tengo el mismo error mo solucionaste?😊

Eror 27

@coloradocardio

2 жыл бұрын

The issue is high amp draw. Usually caused by a worn belt and/or walking deck. One other possibility is the motor is demagnetized. Rare though. I would turn over the walking deck if yours is two sided. Otherwise replace it.**** quick fix apply silicone on the underside of the running belt.