Let me tell you something.... Combusting makes me feel goood! Who you gonna call? _Combusters!_

@user-tk1lf5hi6f

Ай бұрын

When I call Combusters, the call gets redirected to your mom for some reason.

Beautiful description 👌

a slightly similar design also makes gas engines a lot more efficient impressive how old the idea is thanks well explained

Nowadays majority of diesel engines are direct injection as its more efficient than indirect injection

well explained. thnk u.

Soviet GAZ-24 Volga also used forechamber ignition to conserve fuel. Except it was a gasoline engine.

Thanks for the vedio I have a question After the fuel burnt and the pistol goes down what then pushes the pistol back up again

great

Nicely explained

@MKHMomentsOfUS

2 жыл бұрын

Thanks

Are diesel engines these days using precombustion chambers? Golly I didn't even know this was a thing until just now.

The pre combustion chamber was use in the GM V6 and V8 of the 1970's and 80's

@dsdave07

2 жыл бұрын

No it wasn't. They were direct injection. Caterpillar was the main proponent of precombustion chambers.

@robertreznik9330

2 жыл бұрын

@@dsdave07 I thought that the head has an area raised where the glow plug entered the chamber. A round disk was flush with the head to disturb the injector stream and keep the glow plug heat confined for easier starting.

@MilesFromExtraordinary

2 жыл бұрын

@@dsdave07 CUCV

thnku

Mercedes AMG use this tecnology for their f 1 car..

@robertbalu8001

2 жыл бұрын

every F1 engine not only Merc

but this creates a high temperatures in the pre combination chamber because of its small size how it can withstand that pressure and temperature & more over whether it increases efficiency or reduces pollution

@sunilyalagi9733

3 жыл бұрын

Yes yet it is smaller as the fuel gets ignited in the pre combustion chamber, with no time it rushes into the main combustion chamber creating swirling action that leads air n fuel particles into homogeneous mixture. Fuel burns completely n there by fuel efficiency n more power output achieved. This is what I know.

@Nathan0A

2 жыл бұрын

Probably because the mixture within the precombustion chamber is so rich relative to the main cylinder volume, the fuel rich condition lowers temperature considerably

@paradiselost9946

7 ай бұрын

because of its small size? bursting pressures of cylinders increases as diameter reduces... hotter is better. promotes combustion. its a diesel. no fear of pre-ignition or detonation. if its cast iron, it isnt going to have an issue and even alloy is happily kept within limits. the pressure is the same everywhere in the chamber. within limits of the speed of sound, propagation rates. what acts on the piston acts on the head and on the inside of the chamber. (people have this idea that the "flame" is doing the work. no. thats just the combustion process, incandescence. its the heat released during that reaction that creates a rise in pressure. that can travel far faster than the "flame" ever can. blue flames out the exhaust isnt lost push, other than the fact that blue flame is very hot and so the gas leaving is also very hot. it hasnt expanded as much as it could. so it makes a really loud noise as its released... the loud exhaust noise is the waste of energy. not the flame!) anyway, the precombustion chamber... it suffers from the issue that its unswept volume, very hard to clear of exhaust byproducts. and upon compression, there will always be some compressed gas left in the clearance space rather than in the chamber... a diesel generally always runs extremely lean, as it is the heat that ignites the fuel, but as it is confined within the chamber without the full charge of air, along with residual exhaust gas, it isnt quite as good as the initial theory suggests? the piston bowl has the same issue. its unswept volume, can never fully clear it, and it affects flame propagation as the piston descends.. but its necessary as to try and compress all that air into a simple combustion chamber makes it far to thin, surface area to volume ratio means most of the heat of compression is lost to the head and piston crown rather than retained in the air where its needed. along with the swirl induced by a small combustion chamber or bowl. "squish".. it actually has me thinking of a totally different way of doing things now... hmmmm....

@matufujiwara7493

6 ай бұрын

but most pre combustion chamber designs have one good thing. it's that when the combustion happens, it's gonna run lean in that chamber, so the fuel mixture is gonna escape to main chamber. but it does it rapidly cause the chamber mouth is narrow. so this should give you more power on high revs cause you'll have fire running towards the piston at rapid speed rather than fire trying to catch the piston in the non precombustion chamber design.

⚡️

The Last example is indirect inyection?

@mustapha2

3 жыл бұрын

yes

pre combustion is old and inefficient design. It creates high NOx and PM, it also is poor fuel efficient. It was designed because there were no sufficient high pressure injectors awailable at that time.

@justinstearns9723

5 жыл бұрын

Poor fuel efficiency? Tell that to the guys getting mid 20s mpg out of old Chevy 6.2 and 6.5 IDIs in full size trucks.

@dsdave07

5 жыл бұрын

Nope.

@angryrepairman5275

3 жыл бұрын

@@justinstearns9723 Lol, I get over 40mpg in vw 1,9 td indirect injection engine in a 27 year old car.

@yaboileeroy3038

2 жыл бұрын

@@justinstearns9723 yeah just open the exhaust and run a taller rear gear. If you really wanna be fancy, ZF5 swap.

@MarkusTonsaker

2 жыл бұрын

@@justinstearns9723 Tell that to the engineers who would love to design a modern direct injection diesel with no DPF or DEF restrictions.

Mixture? In a Diesel engine? Tike anothah look, mite.

@ddegn

2 жыл бұрын

Which use of "mixture" did you think was incorrect? Diesel engines burn a mixture of fuel and air. Why wouldn't "mixture" be used when describing the fuel injection system?

@dsdave07

2 жыл бұрын

@@ddegn No they don't. The fuel never mixes with the air. The injectors spray fire.

@ddegn

2 жыл бұрын

@@dsdave07 Diesel needs oxygen to burn. The oxygen comes from the air. Diesel isn't like gunpowder which contains its own oxidizer. Diesel needs an oxidizer to burn. Diesel doesn't need a spark but it needs air.

@dsdave07

2 жыл бұрын

@@ddegn You're right, but there's never a mixture. The oxygen is in the compressed air in the cylinder, then the fuel is injected into the air, not a mixture - ever!

@ddegn

2 жыл бұрын

@@dsdave07 I understand you point better now. Thanks. Still even though the diesel and air don't mix before entering the combustion chamber, they still have to mix in order to burn. Is there a better term they should use to describe how the fuel interacts with the compress air?