Porsche 996 shifting issue solved by going back to OEM gear oil!

After changing the transmission oil to Motul Gear 300 this past winter and replacing the shifter this summer, I started having issues where the car resisted shifts under load. The harder the acceleration, the worse the symptoms. Although I experienced this early on, it gradually got worse until I couldn't live it it. This video shows the steps I took to resolve my problem.

Пікірлер: 23

  • @flat6fever680
    @flat6fever6802 жыл бұрын

    I had a Jeep JK Wrangler back in the late 80's early 90's and took it to an independant repair shop to have a transmission gear oil change done. They recommended a full synthetic gear oil. I forget what but maybe Redline or something with red in the name. It would barely shift after that. I took it back and they said it was fine and basically blew me off. I was young and just lived with it. It would shift ok once it was hot but took forever to get hot enough to shift smoothly. I know first hand what a profound difference a gear oil can make on a manual transmission. Thanks for posting this. Good reminder to stay OEM.

  • @PIFDIY

    @PIFDIY

    2 жыл бұрын

    Thanks UserX! Yeah, honestly I wouldn't have expected these results. And not to say that Motul Gear 300 doesn't work well with others, but for me there was a clear difference. Could be a combination of things; I know my 996.2 transmission is different from the 996.1 transmissions. Also the 997 shifter may have changed the throw/engagement points enough where it brought about a higher sensitivity to the fluid. Who knows?

  • @onesecplz
    @onesecplz2 жыл бұрын

    Yup I have exact same issue since switching to motul gear 300. The effect was immediately noticeable after making the change. There are times when I would have a hard time going into first from neutral at a stop. The persistent problem is going from second to third like it doesn’t want to go into third. Only way I gone around this is to allow the shifter to pop into neutral and then go to third. I also did the re alignment with the shifter cable that fixed the first gear issue but not the other. I will eventually switch back to OEM or may be the Mobil Delvac. Blows my mind a simple fluid change makes this difference. Oddly does not effect other gears from third to sixth.

  • @986am
    @986am2 жыл бұрын

    Great video - thank you. Really clear content - about to do the manual gearbox fluid on a 2003 C2 - with OE oil from Porsche as per your video. See if it improves the 1 to 2 when cold…

  • @PIFDIY

    @PIFDIY

    2 жыл бұрын

    Thanks 986am, let us know your results!

  • @jackmitchell5187
    @jackmitchell5187 Жыл бұрын

    Glad to hear you've got that sorted! I like your video! Thanks for sharing 👍When I first brought home my 01 Boxster S 6-speed 70k miles. I had a hard time getting into reverse especially but shifts felt like they needed improvement. Make a long story short, I did replace the trans fluid with swepco 201 and then heard a tip- to clean and fresh lube the linkages that connect to the transmission. (My car had been through 3 owners and the last one must lived on a dirt road because it was everywhere in the engine bay) I also opened up the shift knob boot and lubed the little ball on the left side of shifter that moves inside of the square that pivots up and down... Overall feeling of playing around with shifter blew my mind🤯 and then driving it was easily 60% improvement. Just want to recommend to the people just getting started that you probably still should go with OEM trans fluid. Before buying any of the neat parts that are readily available(and still will be🗝️) a little bit of good ole cleaning lubing and troubleshooting goes a long way. Especially in a 20 year old car.

  • @PIFDIY

    @PIFDIY

    Жыл бұрын

    Great tip, thanks Jack!

  • @Shane1112
    @Shane1112 Жыл бұрын

    What are the parts that you added to your motive bleeder to get it to fill your transmission. I want to do this too

  • @Vet2241
    @Vet22412 жыл бұрын

    Do you have a link to the parts video? Thanks

  • @michaelc4577
    @michaelc45772 жыл бұрын

    What do you use to maintain your dash leather? Looks great.

  • @PIFDIY

    @PIFDIY

    2 жыл бұрын

    Hi Michael, I haven't done anything to any of the leather in the car. Probably left over from previous owners and the dealer detailing before I bought it.

  • @amanite5845
    @amanite5845 Жыл бұрын

    Was the Motul oil black from the beginning? If not somethin looked wrong since it was all black when draining it after only one season.

  • @PIFDIY

    @PIFDIY

    Жыл бұрын

    The lighting made it look dark but the oil was very clean. It wasn't in the gearbox very long and looked fine when it came out.

  • @amanite5845

    @amanite5845

    Жыл бұрын

    @@PIFDIY Ok thats what i thought. Optical illusion then. Btw what kind of exhaust system do you use? I have original PSE with baffles on mine and i find yours a bit louder :)

  • @PIFDIY

    @PIFDIY

    Жыл бұрын

    @@amanite5845 I Fister modded my OEM exhaust. Very happy with it!

  • @patricksullivan6114
    @patricksullivan6114 Жыл бұрын

    can you let me know where you purchased the oil please?

  • @PIFDIY

    @PIFDIY

    Жыл бұрын

    You can google it to find other sources, but I got it at Suncoast.

  • @stevebir1
    @stevebir17 ай бұрын

    I think ! Please check yourself.

  • @PIFDIY

    @PIFDIY

    7 ай бұрын

    I removed your previous comment because it's wrong and may confuse people. PTX is the proper fluid for this transmission.

  • @ol48spring
    @ol48spring Жыл бұрын

    Has every tool and toy on the planet. Trying to save money by skimping on fluid…

  • @andygoodwin1526

    @andygoodwin1526

    7 ай бұрын

    Motul gear 300 isnt cheap!

  • @ol48spring

    @ol48spring

    7 ай бұрын

    @@andygoodwin1526 it’s all money. You save up your ass with diy