Polaris Ranger Prop Shaft Removal and U-Joint Replacement

Ойын-сауық

I see these prop shafts and U joints go out all the time on these machines. In my opinion, they are very under built. If you can hammer out the pin, that might save you some time but I usually just use the method I did to remove the shaft. Some machines may not let you slide the front differential out like I did.

Пікірлер: 16

  • @rodneybilly7389
    @rodneybilly73897 ай бұрын

    You did a really good job young man makes me proud to see young men that know how to work on these

  • @atvrepairsandmore2482

    @atvrepairsandmore2482

    7 ай бұрын

    Thank you. For the rear yoke, I would go to Polaris site or call a dealer to get the part. You can put the vin number in on the website to find the part or the dealer can give you the number. Once I have the part number, I usually order on ebay

  • @rodneybilly7389

    @rodneybilly7389

    7 ай бұрын

    @@atvrepairsandmore2482 I looked on eBay but there was none for the XP model only the Ranger 800 and they won't fit

  • @rodneybilly7389

    @rodneybilly7389

    7 ай бұрын

    @@atvrepairsandmore2482 would you happen to have the part number for the rear yoke?

  • @bigdougss5240
    @bigdougss52405 ай бұрын

    Awesome video my 2018 ranger u-joints went out I watched your video and I went ahead and ordered the tool of Amazon it wasn't but $40 but I changed both u-joints just like you did and it took me about 3 hours.

  • @atvrepairsandmore2482

    @atvrepairsandmore2482

    5 ай бұрын

    Thank you. It’s not to bad but definitely takes some time

  • @cougarforrest
    @cougarforrest Жыл бұрын

    Very very helpful. Saved me a ton of time. Thank you for the great video

  • @clinte9897
    @clinte9897 Жыл бұрын

    Pretty good video, ty.

  • @rodneybilly7389
    @rodneybilly73897 ай бұрын

    Hey guys where is the cheapest place to find a rear yoke for a 2011 Polaris Ranger 800 XP ho model EFI - eps

  • @Quinonesr
    @Quinonesr11 ай бұрын

    What was the model number of the Ujoint? The wind makes it hard to hear

  • @rodneybilly7389

    @rodneybilly7389

    7 ай бұрын

    I could not hear it either buddy that wind was cutting a ruckus

  • @shawnbowman8630
    @shawnbowman863010 ай бұрын

    So all said and done, how long did it take to replace the u joint? I need to do mine and am curious.

  • @atvrepairsandmore2482

    @atvrepairsandmore2482

    10 ай бұрын

    I would say 2-3 hours.

  • @ryanyoung9393
    @ryanyoung9393 Жыл бұрын

    Where are you finding ujoints ? The dealers in Ontario are telling me they are unserviceable and need to replace complete shaft

  • @atvrepairsandmore2482

    @atvrepairsandmore2482

    Жыл бұрын

    I usually order them on eBay or you can maybe cross reference it at a auto parts store. The dealer is lying to you. I’ve replaced a few of them on rangers.