This video takes a quick look at basic asset creation in Plasticity. Version used in video: 24.1.2
Жүктеу.....
Пікірлер: 5
@RicheUK9 күн бұрын
👍
@andreasbramftl110626 күн бұрын
"... circle curve offset from the origin". Is there a possibility to type the offset in somewhere? Or do I need helper lines?
@terryd8692
25 күн бұрын
Press Tab to enter dimensions for shapes. For the offset you should get a dialogue bottom left where you can enter a specific value
@Pixelfondue
25 күн бұрын
Thanks for the assist!
@andreasbramftl1106
25 күн бұрын
@@terryd8692 Didn't find it yet. If you create such a part there's most likel a technical drawing that specifies a x/y midpoint for that circle. The way I do this at the moment is create a X helper line, attach a Y helper line and start the circle.
Пікірлер: 5
👍
"... circle curve offset from the origin". Is there a possibility to type the offset in somewhere? Or do I need helper lines?
@terryd8692
25 күн бұрын
Press Tab to enter dimensions for shapes. For the offset you should get a dialogue bottom left where you can enter a specific value
@Pixelfondue
25 күн бұрын
Thanks for the assist!
@andreasbramftl1106
25 күн бұрын
@@terryd8692 Didn't find it yet. If you create such a part there's most likel a technical drawing that specifies a x/y midpoint for that circle. The way I do this at the moment is create a X helper line, attach a Y helper line and start the circle.