Passat Cabin Light Conversion On My Volkswagen Vento 2021 | POLO VENTO Eurospec
RED LEDS ( 2V -3V)
T10 Bulbs Holders
LED Diode Holders
2 x T10 / W5W Bulbs
2 x 570 Ohm 1/2Watt Resistors
7.5 / 10 Amp Fuse
2meters of wiring (1mm-1.5mm)
#polo #golf #vento #volkswagen #automobile #passat #octavia #skoda
Пікірлер: 17
Great work brother keep it up !!
@dheerajsingh9449
2 күн бұрын
@shsyaoalz3819 thanks brother 🙏 😊
@shsyaoalz3819
2 күн бұрын
@@dheerajsingh9449 brother aap superb seats bhi install karo vento me Ek bande ne kari h polo me...youtube par video bhi hai PRERAK KATARIA naam se Aaap bhi karo agar possible ho to✅
@shsyaoalz3819
2 күн бұрын
@@dheerajsingh9449 brother aap superb seats bhi install karo vento me Ek bande ne kari h polo me...youtube par video bhi hai PRERAK KATARIA naam se Aaap bhi karo agar possible ho to✅
What you are doing is good and innovative. But one small thing is, units are mismatched, Power - Watts, Resistance - Ohms. Good job on DIY
@dheerajsingh9449
19 күн бұрын
Thanks bro 🙏❤️ Actually i was referring to wattage rating of resistor and I said current that I realized after uploading the video 😅 great observation 👍
Nice work man! Thanks for this. Can you share how did you install the ambient light near the dashboard as well? Any link to that ambient light ?
@dheerajsingh9449
16 күн бұрын
Thank bro 🙏 🙌 Here is the link amzn.in/d/03kncxwp In order to install it u have to remove the glove box or just slightly unbolt the screws then there is going to be slight gap between dashboard and glove box that is where u can install ambient and for the storage under ac unit there is going to be 2 screws as well it has enough space to pass the ambient light
@gkautomotive
11 күн бұрын
I'll surely consult you while attempting this. Thank you for sharing the link.
@gkautomotive
11 күн бұрын
How have you powered the ambient light ? Any suggestions on how to remove th USB and direct it using scotch wire tap ?
@dheerajsingh9449
11 күн бұрын
@@gkautomotive for that you'll need a 12v charger , center point of the charger (which has spring action ) is the +ve (bottom point) and Two metal clips around the charger is the -ve, just solder the +ve and -ve with wires then take the +ve end in the Fuse box ( I am using slot no. 16 i.e. ACC) u can refer Fuse box diagram and use the frame bolt behind the stereo for the -ve then it should work with the ignition.
@gkautomotive
11 күн бұрын
@@dheerajsingh9449thank you so much !
Very informative
@dheerajsingh9449
25 күн бұрын
Thanks bro 🙌🙏
this was awesome....as passat one costs over 6k and are hard to source
@dheerajsingh9449
24 күн бұрын
Thanks bro 🙌 6k was old price bro now it costs 10k-12k with harness