P13/27. Camshafts. How to Assemble Toyota Camry 2.4 VVT-i engine: Camshafts
Автокөліктер мен көлік құралдары
Next video: • P14/27. Timing Chain. ...
First video: • P1/27. CLEAN the ENGIN...
Árboles de levas. P13. Cómo ensamblar el motor Toyota Camry 2.4 VVT-i: Árboles de levas
Camshafts. P13. How to Assemble Toyota Camry 2.4 VVT-i engine: Camshafts
Engine type: 2AZ-FE 2.4 and Toyota Camry 2004
Disclaimer:
These videos are intended to offer general information working a car and tools.
The Peter Finn have used best effort in creating the video. No liability can be accepted by the author and publisher for any expense, damage or injury caused by any errors in the information given. In no event shall author be liable for any direct, indirect damages or loss of profit by you or any third party.
Due to factors beyond the control, I cannot guarantee against improper use or unauthorized modifications of this information. Peter Finn assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. I recommend safe practices when working on vehicles and or with tools seen or implied in this video. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Peter Finn.
Work carefully and safely. Also avoid accidents.
Пікірлер: 18
Thank you so much peter, I really appreciate the time that you took in the making of this series. My father and i are replacing the head gasket of my Camry and you are making the job way easier. Your video is useful even a years after it’s upload. Thanks!
@PeterFinnTheCarDoctor
Жыл бұрын
Glad it was helpful!
Excellent work Peter!
@PeterFinnTheCarDoctor
3 жыл бұрын
Many thanks!👍👍👍
It's also important to make sure that NO pistons are in top position, otherwise you will have piston crushing up against valves when you tighten cam shaft.
@PeterFinnTheCarDoctor
7 күн бұрын
Thanks for comment 👍😀
Thanks Peter I don't know if it is correct, but I would put a few drops of oil between every mating surface: like bearing caps, under cam followers etc. because when this engine starts, all those areas will be dry before the oil pump gets oil there. This can cause heat and scoring.
@PeterFinnTheCarDoctor
3 жыл бұрын
Great point!
Excelente tutorial, saludos desde Sonora México *like !!! 👍
@PeterFinnTheCarDoctor
5 күн бұрын
Thanks for comment. 👍😀
Good work I like this job
@PeterFinnTheCarDoctor
3 жыл бұрын
Thank you so much 😀
🙏✅✅✅👍👍👍👍
@PeterFinnTheCarDoctor
Жыл бұрын
👍👍👍👍
U missed number 7
@PeterFinnTheCarDoctor
Жыл бұрын
😁👍
Good morning sar I mes my number setting fab Toyota avensis verso 2az plese help me
@PeterFinnTheCarDoctor
3 ай бұрын
Good comment 👍