This is a video of some 1:76 scale Oxford Diecast Ford Transit Mark 1 vans converted to run on the analogue Faller Car System using the conversion kit by Merryweather Scale Vehicles. The kit comes with a custom-made circuit board, a spacer to attach it to the vehicle, new wheels with a 1mm axle hole, a reed switch, magnets, slide switch, three-way connector, 56 ohm resistor, stainless steel axle, long mounting screw and building instructions.
Other parts are required to complete the conversion. These are; a chosen Oxford Diecast Ford Transit Mark 1 van 76FT100, Faller parts 163001 or 163004 front steering (either will fit), 163206 steering plates Sprinters, 163256 battery 150mah, 163303 7mm motor 0.3 mod, 163502 7mm motor bracket and if necessary, a charger, 161349 or 161690.
Other vehicles are in the prototype stage.