Hey Kevin-cannot tell you how happy I am with this unit you sold me. Very powerful and very well built. Thanks again

@farmerequipment

3 ай бұрын

Thanks for your business!

Excellent video, you seem to have covered everything.

@farmerequipment

3 ай бұрын

Thanks!

@Prospector1300

3 ай бұрын

Outstanding video, very helpful. Question how do you adjust and/or replace the pulleys? Ducar should have your video on their website. Thank you for doing this video.

@kevinfarmer7517

3 ай бұрын

@@Prospector1300 Thanks for watching. The pulleys are pretty easily removed if needed, the one on the engine is just the single bolt (RH thread) and a set screw on the shaft and the one on the drum is a single bolt (LH thread). You may need to use a puller to get them free of the shafts. And as far as adjusting them goes usually you can adjust the belt alignment sufficiently by just shifting then engine in the elongated slots it is mounted to.

@Prospector1300

3 ай бұрын

thank you, your attention to details is appreciated@@kevinfarmer7517

Great video, I'm about to do my first oil change, wondering if you'd have a video for that.

@farmerequipment

Ай бұрын

No, sorry. At least not yet anyway…. Thanks for watching.

I've got one on order.

@farmerequipment

2 ай бұрын

Thanks for watching

Just got one of these. Id say its more of a 4 inch chipper. 5 inches is just too much. Stalls out on 5 inch. But a good chipper so far.

@farmerequipment

25 күн бұрын

I always say they will chip up to approximately 2.5" branches as fast as you can load them in, anything larger than 2.5" will require reduced feed speed to maintain chipping drum RPM.

Thanks, great video I wanted to change the engine oil but the drain plug is kind of innacesible in the front. Do you need something special for the oil change or I missed something?

@farmerequipment

2 ай бұрын

You’re right, the oil drain is not in a very convenient location and it will run out over the frame when draining. I usually use a pump and suck it out through the fill hole to avoid the mess. Or you could look into an extension, something like the “Drainz-it”. Thanks for watching.

Where are you from and where is the nearest dealer to me in New ulm,mn

@farmerequipment

3 ай бұрын

We are from Ontario Canada, this machine is currently only available in Canada.

What is the cost

@farmerequipment

3 ай бұрын

$2100 Canadian, thanks for watching