im getting error showing a solution failure : 1 1. Lack of adequate fixtures for one or more parts 2. Material properties may not be properly defined. 3. Load Increment may be too large or too small. (too small displacements -> convergence failure) what should i do?

Please make a full video tutorial on this pipe bending simulation.

How long should a single simulation last ?

How can i apply the rolling fixture for a tow cart , i want to use this method to pull my cart

@user-pu2zp2ke2l

Жыл бұрын

Hi Anthony, did you found a solution ?

Hi sir 👋 Please i have a problem in bending tube can you help me? 🥰 Thanks 😊

Can you share the file with simulation study ? How to understand Non-linear simulation?

HEY I DID IT SAME BUT STIMULATION IS TAKING TOO MUCH TIME AND NOT GENERATING SHOWING THIS ERROR Solution failure in the First Step may be due to: 1. Lack of adequate fixtures for one or more parts 2. Material properties may not be properly defined. 3. Load Increment may be too large or too small. (too small displacements -> convergence failure)

@1337overclocker

5 жыл бұрын

It sounds like you have some fixture no applied correctly or not applied at all. On top of this, the stresses in the video are unrealistic, but probably occur because a linear elastic material model was used in the nonlinear simulation. In order to simulate yielding in SW simulation, either the stress/strain curve or the tangent modulus has to be defined and a plasticity model choosen in material properties.