Fixed my issue, my brother was screaming I broke his car when he heard a weird noise and thankfully was just some leaves making noise. Easy fix

Thank you so much for this. Shop was trying to charge me $700 to fix. Bought a replacement online for $130 and will be giving this a shot myself today.

Thanks for the informative video. Replaced my cabin air filter and the ac was still making that noise. Found your vid and decided to tackle the Blower motor. Expected to find a bunch of leaves as well but nope. The only thing in there was a small sponge. Removed it put it back together and it was back to normal. Who knew a tiny 1 inch sponge was causing all that. Thanks again for the video.

Thanks for this. My 2013 Sentra blower was filled full with cardboard pieces from rodents!!! Your steps were spot on :)!!!!

Saved me a trip to the mechanic. Turned out to be a small piece of foam that vibrated the entire car lol

Dude you’re a life saver, thank you

Great video Travis. I just acquired a 2016 Sentra and the blower motor was erratic, working when on high but seemed to die out on low. Removed it easily per your fine instructions and turned it on while holding it in my hand. (if you do this be careful, it has some torque and could bugar your hands up) It wouldn't run on low so hit high to get it going and went back to low then it got very slow and rev up periodically with speed going up and down. Worked okay on high. I went to order another one but couldn't resist looking inside. I took the three screws out of the cover where the wiring harness plugs in and pried on the three tabs and removed. Blew out all the black dust from the brushes (was a lot) then dumped about a half bottle of rubbing alcohol in there while spinning it, get a lot on the brushes. Did that a few times and blew it out again with the compressor. Plugged it back in and held with hand and it turns smoothly and at constant speed. Stuck it back in and whole ordeal only took about an hour. Great design by Nissan with the easy access to the blower motor. Would have taken a lot longer trying to figure it out without this video, Thanks again.

Putting the glove box back is the hardest part of the job. I just did it, so I know.

Thank You . This saved me alot of time and money.............>

dude, thank you so much

That helped out a lot

Thanks

Exactamente lo que estaba ocurriendo con mi carro, gracias por el aporte

@RepairNut

7 күн бұрын

De Nada!

Thank you for this do you know where the blower motor resistor is located?

@RepairNut

8 ай бұрын

Nope have not had to replace that yet.

Ya, I had a mouse in mine just today and had to see how difficult it was. I don't think the mouse is doing fine, though 😅

Question, should i disconnect my battery first before i do this?

@RepairNut

8 ай бұрын

I didn't. I don't think you'll have an issue as long as your car is turned off and the fan is not on. Make sure its not in accessory/run position (make sure the fan can't switch on).

@n0rst4thew1cked3

8 ай бұрын

@@RepairNut thanks. I appreciate it for sure

Way more complicated than I thought have to keep going since I have the dash off but getting mad uhhgg

@RepairNut

2 ай бұрын

You can do it! Have some patience. It will rotate in and out once you find the sweet spot.

Where is the tab on the right side? I can’t see mine

@RepairNut

10 ай бұрын

When you start it will be at the very center top, you can't see it but you can feel it. Press down on it and then rotate the whole thing right to pull it out.

@NadiuskaR

10 ай бұрын

@@RepairNut thank you! I’ll try it today.

@jennay798

10 ай бұрын

Do I hold the tab down when twisting it back in place?

@RepairNut

10 ай бұрын

I can't remember but you shouldn't have to. Try it both ways if needed. Keep wiggling it around and it will go into place and you'll feel it. @@jennay798

@jennay798

10 ай бұрын

Been doing it for awhile and it’s still not clicking in

Pls help

You need more fucking light!!!

@RepairNut

6 ай бұрын

I could see it fine, just didn't turn out on camera well. It's an easy job once you get in there.

@JohnSmith-hz2bz

5 ай бұрын

You make it look so easy a blind man could do it. Thanks, great video, straight to the point and precise. @@RepairNut

@pacheco13013

5 ай бұрын

@@RepairNut I was fighting with the video and my car the entire time! But finally got it off and replaced. Saved myself couple hundred bucks, so thanks for the video. I will say it was the easiest video to follow. Other videos on the same issue either talked to much or didn’t actually show the process correctly. This one is easy to follow. Just could hardly see in the video.

@RepairNut

5 ай бұрын

@@pacheco13013 Glad it helped. Ya I didn't plan on making a video at the time so didn't have proper lighting set up. But a pretty easy job. Basically just need to remove glovebox, locate the fan, rotate it to pull it out, and assy is just the reverse. Pretty do-able job.