Looks very nice!

Can we see the results? So no more BSOD? Btw clean job 👍🏼

Nice mate ^^

try to dry more the solder paste with a paper to reduce the flux the result will be more better

Temps and airflow for reball? Nice work

Nice reball, but one ball hasn’t been done properly on right side near the middle

Very good . Total reball . But how do you know how to realign the processor to put it back in the board ? Is there an indicating mark on the other side ?

@fixingmoddingbuilding

2 ай бұрын

There is a small arrow on the board where you line up a corner, you then just need to carefully line it up as best you can.

The solder paste is a low melt solder you'd better use the hot air at 220C to make the slder balls

Hi, Can I extract the files From an rcm loader while connected to the pc?

@fixingmoddingbuilding

2 ай бұрын

Yes

@luislazo2526

2 ай бұрын

@@fixingmoddingbuilding thanks