Neato D7 Side Brush Repair: Cat broke it!
Our cat helped break our Neato D7 by riding on it and playing with the side brush.
This is a walkthrough of how fix a Neato D7 side brush by replacing the original o-ring which quickly wears out.
O-Ring Replacement
amzn.to/3aAnur5
Star T-Handle Hex Key: Primary driver needed to take apart the Neato
amzn.to/3dy4LhQ
Neato D7
amzn.to/2M6Y2jo
___________________________
My Equipment:
Gimbal
amzn.to/2OmhUjp
Microphones:
amzn.to/3jxrCuB
amzn.to/2LAhRQ0
Mounts and Stands:
amzn.to/3cVlg7o
amzn.to/36UOgrI
Пікірлер: 39
Wow bro, this was short, sweet and to the point. Thanks to your video, our vacuum brush is operational again. Greetings from the America of Europe (Switzerland)!
very helpful video 👍 with exchanging the belt on my D6
Thanks for the video, wouldn't have been able to do this repair without it. Love your cat too.
I would note it’s helpful to take a cotton swab with alcohol and clean the rubber debris from the pulleys.
Thank you, I did this and now it runs like new, great video!
Amazing video! Easy to follow. Thank you!!!
Thank you! I followed the instructions and now Betsy's side brush works again.
Soooo helpful! My hero!
Thank you. Very helpful. Greetings from Germany. 😊
Much appreciated.
Thanks very much...problem solved 😀
Hi, great video. How much is the diameter of the o ring?
so what do i do if i did break the ribbon wire connector
Hello , i changed it for the second time , the first time it worked but this time the brush is not working ? Any ideas ? It could be the motor ?
Hi. i changed, but its not working. Any idea?
Thank you for the video. I noticed that my D7 would fire up normally, but when the motor for the side brush kicked in, there was a horrible grinding noise. Followed your video to be able to access the motor, thinking that it may be covered in dust and hair. It wasn't that bad, but replaced the O ring as it looked a bit slack. Also cleaned out the gears (black box) attached to the wheel motor. However, it is still making that horrible grinding noise. Do you think the side brush motor might need changing?
you are my god ha ha thank you!!!!!
Do you have any photos of the placement/positioning of the side brush sensor? It popped up when I wasn't looking and I didn't pay close enough attention to it beforehand to know exactly where it's installed. It looks like at
Hello, thank you for the video. I managed to replace the O-ring and the cleaner is working.
Great video but guess what I did broke the dang ribbon cable connector. Any tips on a replacement? The ribbon is fine just the plastic connector.