NAND Gate using Transistors on a Breadboard
This circuit indicates the working of a logical NAND gate using two transistors.
When either or both the switches are open, the current cannot flow through the transistors to ground. The current flows through the LED instead. This causes the output to go HIGH.
When both switches are closed, both the transistors turn ON. Current flows through their collector-emitter paths creating a short circuit to ground. Therefore the current does not flow through the LED and the output goes LOW.
Пікірлер: 29
I'm from South korea your video is so good!😄
@electronics_champ
11 күн бұрын
Thank you! 😃
Thank bro.dil se thanks.❤❤mera nand gate work hi nhi kr rha tha thanks to you bro it's working now.❤❤❤❤❤❤
great video bro thanks
I love these clear instructions and tutorials! Please continue to make more! BTW, you earned a sub.
@electronics_champ
3 жыл бұрын
Thank you very much. Glad you like my videos. I'll continue to upload more videos on digital electronics and Arduino. So stay tuned!
Is it okay to use C945 as an alternative for BC 547?
Thanks for the clear instructions!
@electronics_champ
3 жыл бұрын
Glad you liked it. Please do watch the other videos in my channel. Thanks again.
Followed these instructions - it sort of works, but the LED only dims slightly when both buttons are pressed - is that what's supposed to happen, or should it turn off completely?
@electronics_champ
3 жыл бұрын
Thank you for watching my videos. I retried the circuit with the same components as mentioned in my video. I see that when both the switches are closed, the LED completely turns OFF. I hope you are using the identical value of resistors and 9V cell as mentioned in the video. I also saw that if the 1K resistor (Between Vcc and Collector of T-1) is replaced with a lower value resistor, the LED does not turn OFF completely when the switches are closed. The LED will turn OFF completely for a higher value of resistance. Please let me know if you continue to face this problem.
@GBart
3 жыл бұрын
@@electronics_champ Thanks for your help! I discovered my mistake - one of my transistors was the wrong kind - works perfectly now!
Bro is it necessary to use resitence Or not
Sir dono button push krne pr bhi led on h ,kya kre
@electronics_champ
Жыл бұрын
Please try again by increasing the resistor between Vcc and Collector of transistor T1 (1:08)
Thanku
This isn't working for me. I have exactly what you wrote and exactly the right wires. I showed to an electrical engineer and he doesn't understand the right portion of the board. It seems there is already a connection from the positive to the negative directly. I push both buttons and it doesn't go off. Are the buttons very specific on how they are placed?
@electronics_champ
Жыл бұрын
Thank you for your interest. Can you please send a pic of your circuit on: Email: shreyas.echamp@gmail.com Instagram: @electronics_champ
Sir dono buttons press krne per bhi.....light off nhi ho rhi hai...kal project submit krna hai, please jaldi btaaiye ,kya kre
@electronics_champ
3 ай бұрын
Resistors aur battery ki value check karye. Agar isme koi change hai to LED theek se respond nhi karega.
It help me to make xor gate
hey bro its not working for me
@electronics_champ
2 жыл бұрын
Please share the image of the circuit on: Email - shreyas.echamp@gmail.com or Instagram - @electronics_champ
Sir, it's not working for me
@electronics_champ
8 ай бұрын
Can you give me some more details about the issue?