Hey there is a print in bambu online prints to hold the cable up a bit on the hot end and on the camera/light box up a bit coupled with the clips on ams it hold them up way higher out of the way! Takes about an hour to print both, great upgrade for the a1 Also get you a poop chute! Great QOL upgrade and no more bowl hanging out under the machine
@TylrVncnt3 ай бұрын
Nice!! I’m looking to implement Multiboard everywhere too haha, how many kg of filament you think you’ve used so far (up to the panels shown in the vid)
@eried
Ай бұрын
less than 5 kg, was very cheap. But I reduced the walls to 2, I am not gonna hang heavy stuff
@nifftyfiftys
17 күн бұрын
@@eriednice! Good info! Im doing 3 walls as the guy says to do and it’s about 95g of filament per 9x9 panel
Пікірлер: 5
Bro me too!
Hey there is a print in bambu online prints to hold the cable up a bit on the hot end and on the camera/light box up a bit coupled with the clips on ams it hold them up way higher out of the way! Takes about an hour to print both, great upgrade for the a1 Also get you a poop chute! Great QOL upgrade and no more bowl hanging out under the machine
Nice!! I’m looking to implement Multiboard everywhere too haha, how many kg of filament you think you’ve used so far (up to the panels shown in the vid)
@eried
Ай бұрын
less than 5 kg, was very cheap. But I reduced the walls to 2, I am not gonna hang heavy stuff
@nifftyfiftys
17 күн бұрын
@@eriednice! Good info! Im doing 3 walls as the guy says to do and it’s about 95g of filament per 9x9 panel