My xi3 is doing the same thing, will this work ?

@thebbztv

Жыл бұрын

I do n ot think it works with the xi3, This fix is for the Tour Pro Ver H. You can email MG tech support and ask if they have something to help.

@custombody4268

3 ай бұрын

Xi series with Pinpoint - no M283 will not work… you need to remove the upper head cover and inspect the red/white wires. They should be twisted and routed like the images on MotorGuides website under Xi FAQs.

Hello, What is the code? Its show M283 then below shows M382. Thanks for the Video.

@thebbztv

Жыл бұрын

Should be M283. If you email me at bill@thebbz.com and ask me for the M Code Chart for MotorGuide and I will email it to you. Bill

Hello i have a xi5 and its doing the same thing

@thebbztv

Жыл бұрын

As for the xi5 I do not have that information. Please contact the MG tech and ask. I will also try and reach out to find the answer. Thanks

@thebbztv

Жыл бұрын

I just got off the phone with MG. Xi doesn't have some of the calibrations. if the motor has power but no satellite then it is either environmental or needs a reset and calibration. If the anchor is dropping and such then it could be ow voltage most likely or a bad board or gps. Go to motorguide.com and on the website there is a troubleshooting guide. Most issues with the Xi are power issues. Hope this helps. Bill

@anthonyshrewsberry7151

Жыл бұрын

Thanks for your help

@clark17forever1

Жыл бұрын

These motorguides are terrible. Same issue

@clark17forever1

Жыл бұрын

Xi5 as well