ok i have 2 wire turn signals one blue and one green is so is the blue wire still for same in this video and green for well ground ?

Any help on a 2002 Ducati Monster 600 converting to 2 wire LED?

Installed new turn signals on the rear. The set came with 5008 incandescent bulbs, 2 wire setup... once rewired and flip the switch they only come on solid and not flashing. Would a load equalizer/ resistor fix this? Tested a 1156 bulb and it works like normal, so I'm assuming it's amperage issue.

Installing 3 wire LED turn lights on 2014 VN900. Bike harness is three wire but I can get the running lamps OR the turn lamps to work, not both. What am I doing wrong?

Thanks for the content, I bought a bruised buddy 125 and need new turn signals

@chaparralmotorsports

Жыл бұрын

Nice 👍

So I got led upgrade for mine.. with resistors and still won't light up any suggestions would help pls thanks

@chaparralmotorsports

3 жыл бұрын

Hi Chris, without looking at your bike/electrical system it's impossible to say where the problem lies. Double back and make sure you've got all the connections correct and they are making good contact.

Can you run incondesent in the front and LED in the rear turn signals.

@chaparralmotorsports

3 жыл бұрын

Hello, you can but you will most likely need a load equalizer to keep things running properly.

Hi, I put led turn signals on the rear of my bike and its sucking all the energy to the rear turn signals and nothing in the front turn signals.. what happened? thanks

@chaparralmotorsports

3 жыл бұрын

Hi Peter, without actually seeing your bike and what was done it's hard to say. Did you use a load equalizer?

Having trouble hooking up 3 wire signals on suzuki boulevard c50

@chaparralmotorsports

2 жыл бұрын

Is there someone local you can have take a physical look at what you're dealing with?

hi I installed all 4 LED turn signals on my Yamaha yzf600r but all 4 turn signals light up when I chose left turn signal all 4 light up and the same when i chose right turn all 4 light up .. any idea how to fix ?? Thankyou

@chaparralmotorsports

Жыл бұрын

Hello, sorry without knowing step-by step how your installation was performed we cannot absolutely say; but it sounds like maybe you need to install some diodes in line of your turn signal wiring.

@grosumihai9341

Жыл бұрын

@@chaparralmotorsports you have totorial for that or picture ?? I m out of this handmade :)

How do I hook up a 3 wire turn signal to a 2’wire bike My old signals were 2 wire. These are incandescent

@tlingitgirl07

3 жыл бұрын

Did u ever get an answer? Why is it so hard to find?

@Neeko_Z

3 жыл бұрын

I’m looking into the blinker genie..

73 model with 2 indicators on dash ,, how to wire in diodes ??

@chaparralmotorsports

2 жыл бұрын

Sorry, not sure.

@01dooman

2 жыл бұрын

@@chaparralmotorsports thank you for replying

Do not change your oem turn signals B4 u read up whats legal and not But my suggestion Replace with oem atleast the casing And blinker but a led bulb can be An option But again check what is legal for the Road/hwy What is accepted by DOT and hwy patrol etc Utube videos may not offer all The legal stuff when in comes To DOT Best of all the oem stuff usually Works unless it comes to modes Or bad component.

@chaparralmotorsports

Жыл бұрын

Thanks for the insight.