How to replace a motorcycle chain 👉🏾 kzread.info/dash/bejne/layotdSaYK_epdo.html

And here I am thinking my chain will fly off if I don't maintain it on a weekly basis 🤣

@miniwarrior7

9 ай бұрын

It will. You'll get tight links and when the tight links hit the sprocket the tension can break the chain and the chain can destroy the clutch cover

@tomwxrd2781

9 ай бұрын

​@@miniwarrior7 big difference between people maintaining it and dumping chain lube on it though, clean it with wd40 and a rag n then put plenty of chain lube on it, then wipe off the excess along the entire chain n your set

@EzioBellic2KOOL

7 ай бұрын

Do not clean your chain with wd40 unless its wd40 silicone as it will break down the o rings causing unreliable chain

@Hellothere-xc5ph

2 ай бұрын

@@EzioBellic2KOOL There’s literally a video online bro of a guy leaving the O rings in a test tube of WD40 for days on end and they were perfectly fine. WD40 ruining O rings is a myth

@RoshamboShow

Ай бұрын

​@Hellothere-xc5ph it will take a lot longer than "days on end" to break down the seal. More like it is the difference in a chain lasting 2years vs 5+ yrs.

Keep in mind, this applies to o ring chains not the regular roller chains those do require lube

Yes exactly. Just a few bottles of WD40 is more than enough. Never over lube

@marcdelgado393

Жыл бұрын

Can’t wd-40 swell the o-rings?

@shrirham489

Жыл бұрын

@@marcdelgado393 i meant this comment in more of a sarcastic sense😂

@JH09SUMIT

Жыл бұрын

@@marcdelgado393 No, tried and tested by Ari Henning, motorcyclists magazine's MC garage. Don't use gasoline to clean your chains tho.

@ineedmorecarrots6063

9 ай бұрын

​@@marcdelgado393you can try the silicone based one if youre worried about it

@marcquirante2383

9 ай бұрын

They're fckin expensive. I use kerosene every 500 km to remove excess grease, oil and dirts. After that just wash with detergent/dishwashing lubricate it after and it's done.

You heard the man, don’t over lubricate your ring… lol😂

@HomesteadOnThePreserve

10 ай бұрын

Yup, just the tip!

You don't want to let those o-rings run totally dry on lube especially if you're running a small front sprocket That sharp bend creates a high torsional force on those o-rings they get pulled deformed and worn same with underneath your rollers If they run dry they will wallow out get all sloppy and causes excessive rattle noise That wax is not a lube it Okay to help keep the rust at bay But I certainly don't use it I use high pressure copper anti-seize applied with my favorite toothbrush to work it down under the rollers handsome loom guard cat's eye diff friction modifier to wipe the o-rings with unless it's extremely dusty then I go with Teflon sprays something with a little PTFE

Your forgetting the center rollers. No o-rings on them.

"You're an idiot and that's okay"😂

The chain is so loud without lube!

Gear oil every 600 miles. No issues here

A very experienced bike mechanic told me you don’t actually have to clean your chain just lube it. What are your thoughts on that?

Just make sure you're cleaning it with something that won't break down the oring

Bro I thought he was going to say some gxsr joke about that ring 😂😂

@therealrealshocker

Ай бұрын

🤣🤣🤣

Finally some common sense..

I hear what you are saying, but when i apply, i do apply 😂

You heard the man, just a small amount of KY so she doesn't go dry

My o rings were starting to go so I bought a chain tool and managed to strip it all down and replace each o ring, it’s as good as new now

Would u do a video of removing and putting back together a chain.

@adobomoto

Жыл бұрын

Already did

@adobomoto

Жыл бұрын

Already did kzread.info/dash/bejne/layotdSaYK_epdo.html

As a GSXR rider, lubricating your ring is essential

Also helps with tooth to chain link interface

I do it on mileage ridden,like 400-500km 😅

@olivierseurin1204

3 ай бұрын

That's normal, especially if it rains as often as where I live. There's constantly this sand/dirt kicked up from the rain, which will act as an abrasive if you only lube your chain

Don’t forget lube also helps improve sprocket life. Metal on metal always needs lubricant.

I’m an idiot ? We ride in clay and wash the bikes every ride. You know what happens to clay on a chain ….

couple months ago my chain snapped and locked the rear hub at 150kmh. Almost shit my pants but I did fart tho..

Imagine cleaning a chain just to get dirty again. Suzuki never had this problem

do you have any tips on how to get rid of rust on disc brakes?

@adobomoto

Жыл бұрын

Apple cider vinegar

@Mordorer

Жыл бұрын

Ride it.

@joeditz48

Жыл бұрын

Ya bro ride it and get the brakes hot, the pads will scrub off light rust. It it's pitted badly then get new rotors

Man I need help lol I can't tighten my chain lmao every time I tighten the castle nut it keeps moving the adjuster plate on the side then it doesn't line up I feel dumb asking but what am I doing wrong

And to lube the unsealed rollers that go against your sprocket

Raw ...got it 😂

Im pretty sure the chain on my new to me 05 r1 is the factory chain 35,000miles not cool but ill get it replaced soon as i can lol

You're supposed to maintain chains?...... I totally haven't been riding on the stock chain for the past 3 years without never once touching it 🙃🤠

Hahaha kabayan i was overthinking of it

How do I know if I have a sealed chain 😮

You're supposed to lube your chain 😮.... Ive had my cbr for almost 2y have never maint it 😅 and it run good

question here, apparently my r25 got some of its o-ring's cut in half and literally slipping out of the chain itself, like how pressing jelly with your fingers can lead it to leak outwards, should i buy new chains instead?

what is the best motorcycle chan? i mean O-ring type? standard type? Y-type? or X-type?

@therealrealshocker

Ай бұрын

X

I fall under the idiot category 😭😭😭💀

Why is overlubing bad?

@SoTiredButWired

Жыл бұрын

Waste and mess. The excessive lube also picks up and holds dirt and debris.

@marcquirante2383

9 ай бұрын

Dirts that can makes chain more friction

I ride in FL so I’m all good lol

I need to clean the lube my chain today

But mine rust so fast

I want a zirk in each pin...lol

My busa snapped it's chain the 2nd time I just don't understand what is happening

@therealrealshocker

Ай бұрын

Too tight?

Its okay to be an idiot guys!

One chain per season.. Heh heh..

Yeah..... Don't wash your bike with water.....use grease to wash your bike......nice bro gg 😭

I'm an idiot and that's okay 😊

Get a viton o ring

Squid tips

you only need the lub when you wash your motorcycle with water!! what? how else do you wash it?

@kevin-ts8te

10 ай бұрын

Waterless wash or detailer spray

Why would you lube your chain? Thats just going to let dirt stick to it easier.

This is idiotic. Which is a first for this channel. It's about temperature and time. If you're on the freeway crossing a desert, the chain is going to cook enough to burn off its lubrication. Probably also true for a track day. The chain wants enough lube so that if the inside gets dry surface tension will pull more lube into the inside. So you need to be aware, and develop a sense of when it needs more lube and to be cleaned. And that can happen in a day.

This guy hasn't got a clue what he's talking about

Ever heard of rollers?