You've made me a believer! Far superior hitch I think when used with an Andersen hitch setup for my 5th wheel trailer. Flat floor, and with Andersen, easy on/easy off.

I researched which hitch to buy. Had I watched this video first, I probably wouldn't have shopped around. You guys design and build hitches as thoroughly as I build race engines. Hitch arrives tomorrow - can't wait. Thanks for the video!

Does this work just as easy with a 36 gallon gas tank?

This video did assist in installing the hitch. However, I did not need to remove the tire or tire shield for the install. The issues we ran into when installing the hitch were the torquing of the bolts and mounting without a hitch holder. Overall, we installed the hitch and it did go well.

How much would a shop charge for a install of this kit ??

what is the measurement from rear to pilot drill hole 5.5 ft bed

@gondorian1006

4 ай бұрын

It's the same

Can this be installed on an F150 with Load Lifter 5000 air bags already installed?

@BWTrailerHitches

2 жыл бұрын

We've looked at this and think it could be difficult to install the hitch with the airbags already installed. It appears that the airbag u-bolt would install over our Turnoverball sideplate.

If I'm not mistaken, your front and rear angle irons covered the tape strips you put ontop of the center tape. If that's the case the tape should have gone ontop of the angle irons that latch onto the center plate.

@gondorian1006

4 ай бұрын

The top part of the angle does not overlap the center portion

is this a 5.5' or 6.5' bed?

@BWTrailerHitches

8 жыл бұрын

This truck had a 6.5' bed.

@devinmayfield9630

8 жыл бұрын

thanks, other than cab clearance issues will this hitch work on 5.5' bed?

@ConnectedCorrectly

8 жыл бұрын

It will fit "all beds" according to the installation instructions.

@tomwilliams1917

7 жыл бұрын

Would you guys make a video installing a hitch on 13 f150?

@ConnectedCorrectly

7 жыл бұрын

GNRK1104... That hitch covers a decade of 1/2 ton Ford F-150s ('04~'14). We'll suggest making a video. Stay tuned...