Mitchmadeinc Tacoma Carrier Bearing Replacement
Replacing the carrier bearing on my tacoma with the solid bearing from Mitchmadeinc
@Mitchmadeinc Instagram
mitchmadeinc?ig...
Carrier Bearing
www.mitchmadeinc.com/product-...
IMPORTANT NOTE: The construction of the factory carrier bearing contains a large rubber bushing. An inherent trait of this bushing is soaking up any/all vibrations that your factory driveline may have.
These vibrations can be caused by
1. Out of Balance drive shaft
2. Dents or damage from off-roading
3. Incorrect pinion angle from aftermarket lift
4. Worn out slip yoke
This carrier bearing will eliminate that rubber bushing that may have been previously masking these vibrations & bring them to your attention.
It should be noted that this Carrier Bearing assembly itself is NOT at fault.
Please run down the list above to resolve any vibrations you may have after installation.
Пікірлер: 17
Thanks for watching guys! Please read the description for links & also some tips after installation!
I literally just now finish doing this job while following your older video lol
@Adv4x4
7 ай бұрын
Haha 3 videos on the subject seems redundant but it’s a common issue!
@gakcanthony
7 ай бұрын
TIP FOR ANYONE DOING THIS JOB: Think ahead and install the U joints to where the grease fittings aren’t blocked by any bolts or by the yokes. Ya, remember how I said I finished? Well, I went to install the driveshaft and realized all of the grease fittings (screws into the center housing of the U joints for Moog), are blocked by bolts and the center yoke, so I had to take everything completely apart and flip them 180°. Kinda weird to explain, I’d include photos if I could, but ya plan ahead and don’t make my mistake
Thank you , this may be my problem , going to take it to a pro .
I’ve been looking for this for years, thxs just bought it
Very well done Sir. Probably not a service I would do myself, but I really appreciate the understanding. Cheers.
@Adv4x4
7 ай бұрын
Thanks Mike! Catching up on some previously recorded videos!! Haha almost caught up and ready for the next big project 😎
@mikemorgan4670
7 ай бұрын
@Adv4x4 Really enjoyed the asmr camping trip video you did awhile back....
@Adv4x4
7 ай бұрын
I’ve been wanting to do another!
looks easy enough! given there was editing magic, but not having a vice to use didnt make it look too bad.
@Adv4x4
7 ай бұрын
It’s not the worst! A vice helps a lot. Or a ball joint tool goes a long way too for installation!
Do you have the part # for 2019 tacoma.. I can't find it 😢😢😢😢😢
that works for 2gen tacoma?
I can't find it..2029 part # please
@mattbotten9519
4 ай бұрын
same part for 2012-2023 and abundantly available? where are you looking?
Did you tighten the one down in your previous video while on the lift with no load? Seems like all the difference?