Very helpful. I bought a used minn kota and am slowly learning what I need to know to be safe out on the water. Thanks!

Old vid but helped me… thank you.

Great video, no steps were skipped. Thanks..

This was very well done. Thank you for explaining the process step by step and giving the fore-warnings i.e. there will be a little gap in there etc. Nicely done.

Thank you. This was a very helpful video. Now I feel confident to replace the prop on my trolling motor.

Thanks bud, this helped my situation out a lot. Peace

Thanks. Made it easier for me to do the same thing for a friend. He had almost the identical problem.

Very helpful - thanks for taking the time.

Pretty crazy how much stuff can get inside/ around the prob. Nice Tips Bruce

Thank you for making the video, much appreciated!

Thanks, good video, it was very informative and so were the comments from "up the creek".

Great video.

Thanks much for the info, Tom

Thank you for the helpful video

Great video.. if the pin gets bended would it cause low performance? I hit my trolling motor hard and now it doesn't go as fast as it was b4 even at the 4 or 5 setting. TiA

This was helpful, Thanks!

What size socket are you using to tight the nut? You said the nut is an half inch nut, so what size socket do I need?

Nice video. It reminded me of a late 70s early 80s kung fu movie. Haha

What is the silver piece behind the pin

My motor was not working my bearing was kinda coming out so I tapped it back in and now the motor works ???? Any idea why that would make it work

@bbassfishes8974

4 жыл бұрын

John Snow No sir. The only thing I would think of, is that the bearing keeps it on track to spin correctly. Other than that, I’m not sure of why it wouldn’t completely work. You may have a bent prop shaft if that is the case. Keep in mind, I’m by no means an expert just a diy guy.

@johnsnow6022

4 жыл бұрын

@@bbassfishes8974 thanks for your response. After watching more videos I think the brush holders are hanging up and not going out onto the armature. By me tapping the bearing helped free the brush holders because when I tap on the side it turns on. Any ways thanks

great video, please do more videos.

What size litter pin?

I noticed that inside of mine there was a small paper like washer as well. What is it that I found?

How did you get the shear pin out mine is stuck?

The Pin of my minn kota traxxis is also broken. Where did you get a new metal pin? Thanks! .-)

@79Satd

5 жыл бұрын

I called minn kota customer service, you will need to give them the serial number

Is there a recommended torque for the nut?

@bbassfishes8974

4 жыл бұрын

Charles Kleypas General rule I’ve always used is a quarter turn past snug.

@charleskleypas4405

4 жыл бұрын

B Bass Fishes Thanks!

Min-Kota??? Minn Kota!

It's NOT a cotter pin