MESR 100 V2 update (almost destroyed it!)

Ғылым және технология

Here is a list of the tools I use in my videos: Please note that the links below are affiliate links, and I make a small commission from sales generated using these links.
My soldering station is a Hakko fx888-23BY: amzn.to/3LBewMm
Soldering tip: amzn.to/3ryybpc
My ESR meter: amzn.to/46f9ahS
My Fluke 115 multimeter: amzn.to/46p1HfU
My Power Supply: amzn.to/48sMDA0
My hot air rework station: amzn.to/3RDhKCZ
Preferred leaded solder: amzn.to/46nIAmE
Chipquick No-Clean flux: amzn.to/48uu7qX
Desoldering wick: amzn.to/3ZqzcfL
My recording gear:
Camera: amzn.to/3PwOmLK
Microphone: amzn.to/46nZmlG
Microscope: amzn.to/46nPXdH
Microscope camera: amzn.to/4565uOr
Camera desk stand: amzn.to/3LAnppc DISCHARGE THOSE CAPS!!
Create this simple bleeder probe to safely discharge caps. NEVER trust that manufacturers have put in bleeder resistors on anything. (I almost destroyed my new meter on a simple error.)
Thank you for watching my video. I hope you'll take the time to like, comment and share this with your friends and subscribe to my channel and ring the bell to get notified when I upload new content 👊👊
Make sure to also check my blog: geirandersen.com/
Want to surprise me and send me something?
Send it to:
Geir Andersen
P.O. box 46
3091 HOF, Vestfold
NO-Norway
Follow me on social media:
Instagram: ▶ / mrgeirandersen
Twitter: ▶ / geirandersen
Snapchat: ▶ nordicsurvival
Tumblr: ▶ / geirandersen
Facebook: ▶ / geira

Пікірлер: 5

  • @980ssbbearcat2
    @980ssbbearcat221 күн бұрын

    If you can remember to use the discharge probes, you should remember to discharge the cap by touching it with a screwdriver or a piece metal object before measuring the cap. I know the 10 ohm resistor is to reduce the spark but will not completely discharge the cap.

  • @daytonagreg8765
    @daytonagreg87657 ай бұрын

    I’m a noob. Can I ask a dumb question? When you said “That one’s COMPLETELY shorted”, what exactly does that mean? I assume that shorted means electricity goes through with little to no resistance. But, without the beep, what kind of “reading” indicates it’s bad? Thank you. Still reading & watching KZread to understand. Thanks.

  • @GeirAndersenRepairs

    @GeirAndersenRepairs

    7 ай бұрын

    @daytonagreg8765 In the case of a diode (where electricity is only supposed to flow in one direction) when electricity flows both ways, it's toast. Electricity is only supposed to go from anode through to cathode and be "stopped" from cathode to anode. If diode mode continually beeps (showing constant flow) in the wrong direction, the diode is bad.

  • @laidman2007
    @laidman200711 ай бұрын

    Is that a 10ohm power resistor? How many watts? Like the discharge tool idea. Thank you.

  • @GeirAndersenRepairs

    @GeirAndersenRepairs

    11 ай бұрын

    @laidman2007 Yes, it’s a 10 ohm 1W power resistor

Келесі