⛐ Check out our Garage to see what tools we use and recommend: www.amazon.com/shop/worldmechanics ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: kzread.info ⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys

Was easy. Other videos all this extra. Straight to the point 💪🏾💪🏾💪🏾

Can low refrigerant cause high pressure reading on the low side? Compressor clicks on, stays on for a few secs then turns off. no or very little cool air comes out. AC works fine as long as you are moving along on the highway.

I have the same car e320 2003 but my ac when i turn it on the ac off or ec off button turns on i have put a new compressor, new expansion valve, no leaks, the fans work and now in changing the ac pressure switch does anyine know where is located at and also the ac sensors or fuses???

Do you have a video on how to replace the center actuator? 2005 E320 Thanks

Do the leak guard/sealant products harm your system? Thanks for the great video. You are so helpfull.

@honchoryanc

Ай бұрын

Yes

Don't hold the key when starting the car, JUST SWITCH ON CLICK AND LET GO.

@ibtixgaming7168

5 жыл бұрын

Ikr it's not the old mechanical keys.

@logannaslund1057

Жыл бұрын

you must be some mechanic 😂😂😂

@logannaslund1057

Жыл бұрын

@@ibtixgaming7168 same goes to you aswell 😂😂

@alanjohnson804

Жыл бұрын

​@@ibtixgaming71686nk0 c z ne😊1 -*

I evacuated my system and I think it needs some kind of reset, because it won't turn on the A/C and recharge the system. I read that if the pressure is to low it will disable the system. How do you reset the A/C on a 2008 E320? I saw instructions where you hold the OFF and REST buttons to get the code, but mine doesn't have a REST button.

@Angel-kz7kz

2 жыл бұрын

I have the same problem did you figure it out ?

@davido1588

2 жыл бұрын

@@Angel-kz7kz yes, it had to be reset using an OBD-II scanner. I used my friends Snap-on scanner.

hi, I ask you a question. i have the same car and i wanted to ask you if your car with air conditioning (a / c) turned off the radiator fan always turns? Thanks in advance

@MuradMuradov717

3 жыл бұрын

No it shouldn’t unless it is very hot

@andreamartiniufficiale

3 жыл бұрын

@@MuradMuradov717 OK thanks instead my fan is always spinning at the first speed

@johnmolefe6765

8 ай бұрын

Having the same problem. How did you sort it out?

@andreamartiniufficiale

8 ай бұрын

@@johnmolefe6765 Hi, 👋 good morning I resolved that by inquiring on the Internet and through the workshop, I learned that it is normal for the fan to run at minimum speed with the engine running. among other things, the w211 is electric, the fan, however, the w210 was attached directly to the engine via its clutch so it always turned. these types of engines probably always need continuous cooling

2006 E350 MB, My climate control has no air coming out after I jump start my, does any one have any idea why? buttons work but no air coming out! Thank you for your help!

@johnmolefe6765

8 ай бұрын

Had the same problem while my alternator was faulty. Serviced the alternator and the problem went away

How many times ok?

Sir hmare gadi me gas recharge nahi ho pa rahi plz btao

Who is that picture

My Mercedes-Benz W211 E280 4Matic 2007 blows warm air on driver side but cold on passenger. Can someone guide me please?

@rekanylmaz3787

3 жыл бұрын

@Mohammed Talha Hi Mohammed, I recharged my refrigerant and it works perfectly now!

@tequilashots875

3 жыл бұрын

@@rekanylmaz3787 when you say you recharged do you mean you added Freon?? I have the exact same problem.

@rekanylmaz3787

3 жыл бұрын

@@tequilashots875 I added some refrigerant.

@azri-za

2 жыл бұрын

My W212 same problem...I will try add gas...hope it works

My CAR has between 50 and 60. Is that enough? W211

What about resetting the a/c compressor to turn on... the blinking a/c light won’t allow you to add freon

@westinthe123456

5 жыл бұрын

Do u know how to reset the compressor to add freon, my light blinking not allowing me to add freon.

@gspadez

5 жыл бұрын

roberto aldana need star or compatible software to unlock compressor clutch ...

@westinthe123456

5 жыл бұрын

Gspadez tooreal hey thanks, I got it done yesterday, reset the code n was able to charge the system, thanks again.

@gspadez

5 жыл бұрын

roberto aldana is that what your shop used or you found a compatible scanner ?

@westinthe123456

5 жыл бұрын

Gspadez tooreal I have an Autel scanner, I just didn’t know I had to erased the codes for the compressor to work. I guess any scanner able to read and erased codes will work.

Ok 👌

Good one but that long hold on key would give u trouble to starting

@logannaslund1057

Жыл бұрын

😂😂😂 you must be some mechanic

@zahrasnasiarab1718

Жыл бұрын

Hahaha no am not but I own 211 and I know starting just turn key for fraction of a second n it's boom

@OnlyKelp

Жыл бұрын

@@logannaslund1057 he’s right though, what’s your point?

@logannaslund1057

Жыл бұрын

@@OnlyKelp my point was it was a goofy comment….. you are not going to mess up you stater by letting the key turn for a second or even two lmfao maybe holding it down for 10 seconds and then retrying it for another 20 seconds not a split second 😝 lol

My car is messing .. look.. left (driver side comes hot 🔥 air. Right (passenger) side comes cold air. I don't know what to do!...😳

@Imthecosta

4 жыл бұрын

take it to an air conditioning car place and ask for an air conditioner AC RECHARGE.

@WALKBO1

3 жыл бұрын

Your car most likely has dual temp. Most Honda’s and Mercedes have this in their car where you can set one side to be hot or cold. There are 2 knobs that look exactly the same with a blue and red color painted on it. Locate these both and set them both to blue and you will be set

the passenger side is much cooler than the driver side, almost no AC at all....what could be wrong?

@Ray_Yang182

3 жыл бұрын

The water heater valve located under the wiper blades is mulfunctioning

@AJlion

2 жыл бұрын

Passenger side is where the blower is

@honchoryanc

Ай бұрын

​@@Ray_Yang182 not a blend door?

@robert_murphy916

5 күн бұрын

@@Ray_Yang182are you talking about the heater control valve

BAD instructions on can position. Read the instructions on the can please before advising your 'knowledge' on the internet.

This is not the way to recharge your AC

😈 this is not a professional work and Exhaust temperature is also bad... it should be wide under 10 degrees Celsius - so it's already too much to have a perfect working condition

@mr.kaiwolfman511

5 жыл бұрын

Her's my feedback after the chance of the AC- compressor and professional charge of R134a : Air blowout is at 3-4 Celsius degrees ! THIS is a accurate working System...

Bad directions. You need to vacuum the low pressure port first so you will not introduce air in there.