I have been searching for weeks and couldn't find the same problem, I changed the MAF. Map, EGR Valve and solenoid, Swirl Flaps and actuator and still had the same problem. I checked all the intercooler hoses for leaks, no issues, but the problem remained, until I finally checked the solenoid for the Waste Gate actuator and found a bad connection, I tested the car and BINGO

@evosgarage

5 ай бұрын

Man, I'm so happy to hear you got the car running property again😁🤜🏼🤛🏼

could someone help w210 270 cdi when I start the car it won't go over 3000 rpm, only after about 20-30 minutes of driving it starts working and pulls normally

Same problem on a 2002 w163, thanks for uploading.

@evosgarage

Жыл бұрын

I'll be glad if this video manages to help even a single person! Thanks for watching! I really appreciate it 👌🏼

@ranat5526

Жыл бұрын

@@evosgarage Changed the sensor to no effect, I will now trying the other things you pointed out in the video. Thanks once again.

@evosgarage

Жыл бұрын

@@ranat5526 Rana get a cheap Bluetooth OBD2 scanner and the torque app or carly app and scan the codes so you can pin point the problem in your car and then go from there before you start throwing more parts at the car! Let me know if you need any help when you get the codes scanned! 👍🏻

@ranat5526

Жыл бұрын

​@@evosgarage I undid the egr and it's was fully blocked, going to do a clean up and removing the swirl flaps along with a Mr muscle oven cleaner blast on the turbo.

@blankmasterfishing

Жыл бұрын

@@ranat5526 That sounds like that most likely will be the cause of your problems. Let me know when manage to fix it. I'd love to hear it! 👍

Everytime i get diagnostik on repair they say air mass sensor i have buyed like 5 ones😭😭😭😭

Where did you get that push down part from . Great video by the way .

@evosgarage

6 ай бұрын

I got it from Mercedes!🤜🏼🤛🏼

Nice video! What's your experience with this engine? is it worth it above the 3.2l petrol/gas engine?

@evosgarage

Жыл бұрын

If I could choose I would prefer the 3.2 inline 6. The engine from the 320CDI.

@ramonbs6075

Жыл бұрын

@@evosgarage ok. But between the 270cdi and the 3.2l v6 petrol/gas?

@evosgarage

Жыл бұрын

@ramonbs6075 unless you live in dubai or the USA I would recommend the 270CDI as the 3.2 v6 is known to be veeeery thirsty😉

Really good vid thank mate

@evosgarage

10 ай бұрын

Glad you enjoyed it🤜🏼🤛🏼

I have the same problem with my 2009 C c220 cdi. Only after its warmed up and engine under stress, something happens, no kick down and won't go over 3000rpm.....I will attempt to change the MAF sensor and let you know.

@evosgarage

3 ай бұрын

Hi mate! Do it, it will probably fixed your problem! Thanks for watching 🤜🏼 🤛🏼

I have the same problem with my w210 can u help even when its in P Or N cant go past 300

@evosgarage

Жыл бұрын

Hi Rei! I also have a W210 but it's a 300td. I hope this helps you, in the past I had a similar problem in it, I replaced the MAF sensor, Map sensor, EGR, Both vaccum solenoides and all the vaccum hoses, none of that fixed the problem, in the end it was the fuel tank pre filter that sits under the fuel tank, it was completely clogged with gunk, replaced that and 30000 miles later the car has been running like a dream. check that in your car, you never know. 👍

@reibelalla2266

Жыл бұрын

@@evosgarage thank you very much i will check it

My 2002 c220cdi has this as an intermittent prob, pull over turn off start again its fine!...till next time🙄

@evosgarage

Жыл бұрын

Hi mate! I would suggest you get the codes scanned with a cheap Bluetooth obd2 reader. That's likely to point in the right direction and it might be something very simple to solve!👌🏼 It seems the ecu going into limp mode and there must be a good reason for it but it can be something simple as MAF sensor for example.

@shaunmcclory8117

Жыл бұрын

@@evosgarage ok thanks although i have a more pressing issue with it at min, it is stuck in nuetral wont go in reverse or park, sort of half goes into drive but not as far as normally lever should go but at least i can move it forwards, i have just bought a used lever and gear selector and 🤞 that will sort it

@shaunmcclory8117

Жыл бұрын

Hi quick update which may be of help to others in future, i replaced the gear shifter module with a second hand unit as three diff sources said it would not need programming on a2002car WRONG! A nightmare time with lots of issues (stuck in 1st, no reverse saying R when im driving!.stuck in 4th..and others!) Took it to a magic auto elec who took all the "brains" out of my old shifter and put them in the new one and it is now working fine after a week👍 now its pouring black smoke and loss of power though🙄 bloody vehicles eh😅

Ik heb luchtvolumesenso vervangen en is opgelost

@evosgarage

3 ай бұрын

Good to hear you managed to solve your problem 😁🤜🏼🤛🏼